Operating instructions/Installation instructions

Supervisor level
95
Running a RemoteUpdate
If a RemoteUpdate is available for your
washing machine, it will be displayed
automatically when the Supervisor level
is open.
You can choose to start the RemoteUp-
date immediately or wait until later. If
you select “Start later”, the prompt to
run the RemoteUpdate will be displayed
again the next time you switch on your
washing machine.
The RemoteUpdate can take a few
minutes.
Please note the following information
about the RemoteUpdate function:
- You will only receive a message when
a RemoteUpdate is available.
- Once a RemoteUpdate has been in-
stalled, it cannot be undone.
- Do not switch off the washing ma-
chine during a RemoteUpdate. Other-
wise, the RemoteUpdate will be
aborted and will not be installed.
SmartGrid
The SmartGridsetting is only visible if a
WiFi network has been set up and ac-
tivated. This function can be used for
starting your tumble dryer automati-
cally at a time when your energy sup-
plier’s energy costs are most econom-
ical.
Activating SmartGrid gives the timer sen-
sor control a new function. Use the
“Timer” sensor control to configure
SmartStart. The washing machine will
then start within the timeframe specified
by you when it receives a signal from
your energy supplier. If a signal has not
been received from the energy supplier
by the latest start time set, the washing
machine will start automatically.
Factory default: Off