Operating instructions/Installation instructions

Installation and connection
*
I
N
S
T
A
L
L
A
T
I
O
N
*
70
Installation surface
A concrete floor is the most suitable in-
stallation surface for this machine. It is
far less prone to vibration during the
spin cycle than wooden floorboards or
a carpeted surface.
 The machine must be level and se-
curely positioned.
 To avoid vibrations during spinning,
the machine should not be installed
on soft floor coverings.
If installing on a wooden joist floor:
 Install the machine on a plywood
base (at least 2' 3 9/16" x 1' 11 5/8" x
1 3/16" (70x60x3cm)). The base
should span several joists and be
bolted to the joists and not only to the
floorboards.
Tip: If possible, install the machine in a
corner of the room. This is usually the
most stable part of the floor.
Removing the shipping struts
 Remove the left and right caps.
1. Pull on the secured cap stoppers
2. and use a screwdriver to release the
catches at the top and bottom.
 Using the wrench supplied, turn the
left-hand shipping strut 90°.