Operating Instructions Vacuum Cleaner S 246i - S 252i To prevent accidents and machine damage, read these instructions before installation or use. UV M.-Nr.
Contents Contents IMPORTANT SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Caring for the environment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Disposal of the packing materials . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Guide to the vacuum . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Before using the vacuum . . . . . . . . . . . . . . . . . . . . .
IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE WARNINGTo reduce the risk of fire, electric shock or injury: Before using Check the voltage rating of the vacuum cleaner before connecting the power cord to an electrical outlet. Your power source should correspond with the voltage rating plate located on the underside of the vacuum. Use only household AC outlets.
IMPORTANT SAFETY INSTRUCTIONS Do not allow the vacuum cleaner to be used as a toy. Close attention is necessary when used by or near children. Do not pull or carry by the cord, use the cord as a handle, close a door on the cord, or pull the cord around sharp edges or corners. Do not run the appliance over the cord. Keep the cord away from heated surfaces. Do not unplug by pulling on the cord. To unplug, grasp the plug, not the cord. Do not handle the plug or vacuum with wet hands.
IMPORTANT SAFETY INSTRUCTIONS Accessory use Maintenance and care The Miele Electrobrush is a motor driven accessory for use only with Miele vacuum cleaners. It must not be used with vacuum cleaners produced by another manufacturer. A damaged power cord must only be replaced with a genuine Miele cord by an authorized service agent. When vacuuming with the Miele Electrobrush or Turbobrush, do not touch the rotating brush.
IMPORTANT SAFETY INSTRUCTIONS Disposal of an old appliance Before discarding an old vacuum cleaner, please cut off the power cord and render the plug useless. Ensure the appliance presents no danger to children while being stored for disposal.
Caring for the environment Disposal of the packing materials Disposing of the dustbag and filters The cardboard box and packing materials protect the appliance during shipping. They have been designed to be biodegradable and recyclable. Genuine Miele dustbags and filters are made of environmentally friendly materials. They can be thrown out with the household trash provided the vacuum has not been used on restricted materials. Ensure that any plastic wrappings, bags etc.
Guide to the vacuum 8
Guide to the vacuum 1 Power cord 2 Cord rewind switch 3 Suction power selector * 4 On-Off switch 5 Release button for accessories compartment 6 Dustbag change indicator 7 Elbow 8 Dust compartment lidrelease 9 Handpiece 10 Air inlet valve 11 Locking button 12 Telescopic wand * 13 Telescopic wand release button * 14 Fold-out wand bracket * 15 Carrying handle 16 Park-System 17 Floor brush 18 Dustbag 19 Dust compartment filter (motor protection) 20 Exhaust filter (SUPER ai
Before using the vacuum Attaching the suction hose ^ Insert the elbow into the suction socket. Removing the suction hose ^ Press the release buttons at the side of the elbow and lift the hose from the socket. Connecting the suction hose and the telescopic wand ^ Fit the handpiece of the suction hose firmly into the wand. (Ensure that the plug connectors line up). Turn the handpiece and wand in opposite directions until they lock with a click.
Before using the vacuum Inserting the telescopic tubes (depending on model) Both sections of the telescopic wand have locating arrows. ^ When connecting the two tubes, ensure that the two arrows point to each other. Adjusting the telescopic wand (depending on model) One part of the telescopic wand is inside the other and can be adjusted to your height for comfortable vacuum cleaning. ^ Press the telescopic tube release button (see arrow) to release the tubes and adjust to the required height.
Before using the vacuum Attaching the floor brush ^ Insert the telescopic wand into the floor brush and turn in either direction until it locks with a click. ^ To release the floor brush from the telescopic wand, press the locking button (see arrow) and pull the wand out of the floor brush. The floor brush is suitable for cleaning carpets, rugs, and hard surfaces. For flooring susceptible to scratches, use one of the special Miele floor brushes (see "Optional accessories").
Included accessories The accessory tools for cleaning tough to reach areas are located in the accessory compartment. – Crevice nozzle – Upholstery tool ^ Press the release button to open the accessories compartment lid. ^ Remove the accessory tool. ^ Close the lid.
Included accessories The different tools can either be fitted to the handpiece or to the telescopic wand. Crevice nozzle For cleaning in folds, crevices or corners. Upholstery tool For cleaning upholstery, mattresses, cushions, curtains, covers, etc.
Use Power cord Unwinding ^ Hold the plug and unwind as much of the cord as you need (maximum length 21’ 4" [6.5 m]). ,If the vacuum is operated for more than 30 minutes, atleast 14 feet (4.3 m) of the power cord must be unwound to prevent overheating. Rewinding ^ Unplug the vacuum from the outlet. ^ Step on the rewind switch to automatically rewind the power cord. Lightly hold the plug so that it does not whip around when rewinding.
Use Turning the vacuum on and off To turn the vacuum cleaner on or off: ^ Step on the On-Off foot switch. ,To prevent static discharge, your hand must touch the metal inlay on the underside of the vacuum handpiece. Be certain to continuously touch this inlay when vacuuming fine dust, flour, or saw dust as these materials are most likely to create static discharge. To further prevent static discharge, pull the vacuum along by the hose with one hand while holding the handpiece in the other.
Use Selecting the suction power (models with suction power selector) The suction power can be regulated to suit the type of flooring. Select the middle suction setting (symbol d) for smooth and hard floors and a higher setting for carpets. Rotary selector ^ Turn the suction power selector to the appropriate setting.
Use Opening the air inlet valve The air inlet valve can be opened for a quick reduction of suction, e.g. when moving from a carpet to an area rug. ^ Slide open the air inlet valve just enough for the floor brush to move easily.
Use Transport and storage (models with wand bracket) For easier transport and storage, the telescopic wand can be attached to the vacuum handle. ^ Stand the vacuum cleaner vertically. ^ Unfold the wand bracket and hang it on the handle of the vacuum. The wand bracket can be turned to hang off either side of the vacuum handle. Park-System A Park-System has been designed for conveniently parking the telescopic wand during pauses.
Use Suction level indicator This indicates when the dustbag needs to be changed. ^ Set the suction power selector ( if present) to the highest setting and make sure the air inlet valve is closed. ^ Hold the wand, with the floorbrush attached, off the floor. Turn on the vacuum and check if the red marker completely fills the indicator window. ^ If the red marker fills the window, change the dust bag even if it is not completely full.
Vacuum care When to replace the dustbag and filters Dustbag Change the dustbag when the red marker in the dustbag change indicator fills the display. Exhaust filter (SUPER air clean) A "SUPER air clean filter" is included with each box of Miele dustbags and should be changed when starting a new box of dustbags. Where to purchase new dustbags and filters Replacement dustbags and filters may be purchased from your Miele vacuum dealer. Only use genuine Miele F/J/M dustbags.
Vacuum care ,Always turn off and unplug the vacuum cleaner before performing maintenance or cleaning. Changing the dustbag ^ Open the dust compartment lid by pressing the release button and raising the lid until it clicks into place. ^ Grasp the card collar by the two finger holes and pull it out from the dustbag holder. The dustbag has a flap which closes automatically to prevent dust escaping when the dustbag is removed.
Vacuum care ,Only use genuine Miele dustbags and filters to ensure optimum results and safety. ^ To insert a new dustbag push the collar securely into the frame as far as it will go. Do not unfold the dustbag when you take it out of the box. If it is unfolded or not inserted properly the dust compartment lid will not close. ^ Close the dust compartment lid firmly. It should click into place.
Vacuum care Changing the filters Exhaust filter (SUPER air clean) The "SUPER air clean filter" is a fine filter capable of trapping microscopic dust particles. ^ Open the dust compartment lid. ^ Open the filter frame and remove the used "SUPER air clean filter". ^ Insert the new "SUPER air clean filter". It can be inserted either way up. ^ Close the filter frame. Dust compartment filter ^ Open the dust compartment lid. ^ Change the filter. ^ Close the dust compartment lid.
Vacuum care Changing the thread catcher The thread catcher pads on the bottom of the rug and floor tool should be checked occasionally. Replace the pads if they appear worn. ^ Use a screwdriver as shown to remove the thread catcher from the slot. ^ Press the new thread catcher into the slot. New thread catcher pads may be purchased from your Miele vacuum dealer. Removing threads or hair wrapped around the roller 1. Unlock the axle lever. 2. Pull out the roller axle. 3. Take out the roller.
Vacuum care ,Always turn off the vacuum and unplug it from the outlet before performing maintenance or a repair. Vacuum cleaner and accessories The external surfaces of the vacuum cleaner and of the accessories can be cleaned with a slightly damp cloth or with a cleaner suitable for plastic. ,Do not use abrasive, glass or all purpose cleaners! They will damage the surface.
Frequently asked questions What if the vacuum cleaner turns off while vacuuming? Possible fault Fix The vacuum has overheated. The temperature limiter switched off the vacuum automatically. Turn off the vacuum at the On / Off switch. Check the telescopic wand and the suction hose for blockages. Replace the dustbag or filters if necessary. Unwind the full length of the power cord. Allow the vacuum to cool down for 30 minutes.
Technical Service In the event of a fault which you can not correct, please contact: – Your Miele Dealer or – The Miele Technical Service Department USA 1-800-999-1360 techserv@mieleusa.com CDN 1-800-565-6435 service@miele.ca When contacting the Technical Service Department, please quote your vacuum model number. The model number can be found on the silver data sticker located on the underside of the vacuum.
Optional accessories Turbobrush Recommended for cleaning crushed pile on low nap rugs or carpets. The turbobrush is mechanically driven by the suction power of the vacuum. No electrical connection or electrical hose is necessary. Hand Turbobrush The hand Turbobrush is intended for vacuuming upholstery, mattresses, car seats, carpeted stairs, etc.
Optional accessories Hard floor brush For cleaning sturdy hard floors, e.g. tiles and stone floors. Parquet floor brush The parquet floor brush has natural bristles for vacuuming scratch-sensitive hard floors, e. g. parquet and laminate. Mattress tool For vacuuming mattresses and upholstery. Even deep crevices of a mattress can be vacuumed easily.
Optional accessories Radiator brush For cleaning radiators, narrow shelves or crevices. ^ Attach the radiator brush to the crevice nozzle. Dusting brush For dusting delicate objects, woodwork such as base boards and window sills. The head of the dusting brush can be swivelled for easier cleaning. Universal brush For dusting books, shelves, etc.
Optional accessories MicroSet Specially designed for cleaning small objects and difficult to reach areas (such as PC keyboards, stereo equipment, carved furniture, models etc.) The MicroSet includes: – micro hose with combi nozzle, – micro dust brush, – micro crevice nozzle, – angled extension. CarClean Set Plus Specially designed for cleaning narrow crevices, tight upholstery, loose floor mats and tight spaces in a car.
All rights reserved / 0103 This paper has been bleached without the use of chlorine. M.-Nr.