Operating instructions Vacuum cleaners S 700 - S 718 To avoid the risk of accidents or damage to the appliance, it is essential to read these instructions before using it for the first time These operating instructions apply to standard models S 710 - S 718 and to Special Edition models which are distinguished by names rather than model numbers. Downloaded From Vacuum-Manual.com Manuals en - AU, NZ M.-Nr.
Contents Caring for the environment Description of the appliance Warning and Safety instructions Preparing for use Accessories supplied Using the accessories supplied Use Mains cable . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16 Switching on and off . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16 Adjusting the suction power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Caring for the environment Disposal of packing material Disposal of your old appliance The transport and protective packing has been selected from materials which are environmentally friendly for disposal and can normally be recycled. Electrical and electronic appliances often contain materials which, if handled or disposed of incorrectly, could be potentially hazardous to human health and to the environment. They are, however, essential for the correct functioning of your appliance.
Description of the appliance Downloaded From Vacuum-Manual.
Description of the appliance a Hand piece b Air inlet valve c Release button d Telescopic suction tube* e Telescopic tube release button* f Dust compartment release button g Dust compartment filter (for motor protection) h Dustbag i Standard floorhead j Carrying handle k Parking attachment l Exhaust filter* m Mains cable n Foot control for automatic cable rewind o Suction power selector* p Parking system q On/Off switch r Accessories compartment s Dustbag change indicator t Release button for accessories co
Warning and Safety instructions Correct application This vacuum cleaner meets statutory safety requirements. Improper use can, however, lead to personal injury and material damage. To avoid the risk of accidents and damage to the vacuum cleaner, read these instructions carefully before using it for the first time. They contain important notes on its safety, operation and maintenance. Keep these instructions in a safe place and ensure new users are familiar with the content. Pass them on to any future owner.
Warning and Safety instructions Technical safety ~ Ensure that the connection data on the data plate (voltage and frequency) match the mains electricity supply. It is essential that they match to avoid damage to the appliance. ~ If the cable is damaged it must be replaced together with a complete cable rewind. For safety reasons this must only be done by the Miele Service Department or a Miele authorised service technician.
Warning and Safety instructions Correct use ~ To avoid the risk of damage, do not use the vacuum cleaner without the dustbag, dust compartment filter and exhaust filter in place. Otherwise it could get damaged. ~ If a dustbag is not inserted, the dust compartment cover does not normally close. Do not force it. ~ Do not vacuum up any water, liquid or damp dirt. This will cause major faults and could seriously impair the functioning and electrical safety of the appliance.
Warning and Safety instructions Accessories Miele accessories including floorheads, filters and dustbags are available to order from your Chartered Agent or the Miele Spare Parts Department. ~ To avoid the risk of injury when vacuuming with a Miele Electrobrush or Turbobrush, do not touch the rotating roller brush. ~ It is not advisable to vacuum directly with the handle, i.e. without an accessory attached as the rim could get damaged and you could hurt yourself on sharp edges.
Preparing for use Attaching the suction hose ^ Insert the hose connector into the socket until it clicks into position. Removing the suction hose from the cleaner ^ Press the release buttons at the side of the hose connector, and lift the hose from the socket. Connecting the suction hose and the suction tube ^ Insert the hand piece of the suction hose into the suction tube until it clicks into position. To do this, line up the guides on the two pieces.
Preparing for use Your vacuum cleaner is fitted with one of the following suction tubes, depending on model: – Connecting tubes – 2-part telescopic tube Connecting the suction tube sections Both sections of the suction tube have locating arrows marked on them. When connecting the two sections, ensure that the two arrows point towards each other.
Preparing for use Fitting the standard floorhead ^ Push the suction tube into the floorhead and turn it clockwise or anti-clockwise until it clicks into position. ^ To release the floorhead from the suction tube, press the locking button (see arrow) and pull the suction tube away from the floorhead. The floorhead can be used for all normal cleaning of carpets and rugs. It can also be used with the brush protruding to vacuum hard flooring.
Accessories supplied Other tools, in addition to the floorhead(s), are supplied with the vacuum cleaner to help deal with various types of cleaning. a Crevice nozzle b Dusting brush c Upholstery nozzle Taking the accessories out ^ Press the release button to open the accessories compartment lid. ^ Take out the accessory you require. ^ Press down firmly on the lid to close it. Downloaded From Vacuum-Manual.
Using the accessories supplied The different tools can either be fitted to the hand piece or to the suction tube, as required. Standard floorhead For general use and also for vacuuming stairs. For safety reasons when vacuuming stairs it is best to start at the bottom of the stairs and move upwards. Crevice nozzle For cleaning in folds, crevices or corners. Downloaded From Vacuum-Manual.
Using the accessories supplied Dusting brush For cleaning skirting boards, ornate or carved articles, etc. The head of the dusting brush can be swivelled to attain the best cleaning position. Upholstery nozzle For cleaning upholstery, mattresses, cushions, curtains, covers etc. Downloaded From Vacuum-Manual.
Use Mains cable Unwinding the cable ^ Pull out the mains cable to the required length (max. approx. 6.5 m). ,If vacuuming for longer than 30 minutes, the mains cable must be pulled out to its fullest extent. Otherwise there is a danger of overheating and damage. Rewinding the cable ^ Switch off at the wall socket and remove the plug. ^ Press the rewind foot switch. The cable will rewind automatically. Switching on and off ^ Press the On/Off switch.
Use Adjusting the suction power The suction power can be regulated to suit the type of flooring. The higher the wattage, the more powerful the suction. Reducing the suction power reduces the amount of effort required to manoeuvre the floorhead.
Setting down, transportation and storage Parking system A parking system has been designed for conveniently parking the vacuum cleaner during pauses. ^ Slot the floorhead into the parking attachment at the back of the vacuum cleaner. Transportation and storage ^ Stand the vacuum cleaner upright when it is not being used and during storage. ^ Slot the floorhead downwards into the parking attachment on the side of the cleaner. ^ If your vacuum cleaner has a telescopic tube, retract it fully.
Maintenance and care ,Always disconnect the vacuum cleaner from the electricity supply for maintenance work and for cleaning. Switch off at the wall socket and remove the plug. The Miele filter system consists of three filters which must be replaced from time to time to ensure that your vacuum cleaner performs efficiently.
Maintenance and care When to change the dustbag Change the dustbag when the colour marker in the dustbag change indicator fills the display, or sooner if it is no longer effective (see possible reasons for this below). Miele dustbags are disposable, and designed for single use only. Do not attempt to re-use them as suction would be reduced. Checking the dustbag change indicator ^ Attach the standard floorhead to the suction tube.
Maintenance and care Replacing the dustbag ^ Press the release button for the dust compartment lid and raise the lid as far as it will go. ^ To remove the dustbag, hold the bag by the collar and pull it out of its holder. The dustbag has a closing flap which closes automatically when the dustbag is removed to prevent any dust escaping. ^ Fit the new dustbag into the holder as far as it will go. Leave it folded up when you take it out of the box.
Maintenance and care When to change the exhaust filter Depending on the model, your vacuum cleaner will be fitted as standard with one of the following exhaust filters: a a Super Air Clean filter, Replace this filter every time you start a new packet of Miele dustbags. A Super Air Clean exhaust filter and a dust compartment filter are supplied with every packet of Miele dustbags. b an Active Air Clean filter (black), c an Active HEPA filter (blue). These types of filter need to be changed approx.
Maintenance and care Replacing the Super Air Clean filter Do not use more than one exhaust filter at a time. ^ Open the dust compartment lid. ^ Release the filter grille and raise it upwards. Grasp the used Super Air Clean filter by the clean, unsoiled section (see arrow) and take it out. ^ Replace it with a new Super Air Clean filter. If you wish to replace the Super Air Clean filter with an Active Air Clean filter or with an Active HEPA filter see "When to change the exhaust filter".
Maintenance and care Replacing an Active Air Clean filter or a HEPA filter Do not use more than one exhaust filter at a time. ^ Open the dust compartment lid. ^ Release the catch and remove the filter. ^ To insert the new filter, fit it so that it engages at the back and then close the catch. If you wish to replace the Active Air Clean filter or the Active HEPA filter with a Super Air Clean filter see "When to change the exhaust filter". ^ Close the dust compartment lid firmly. It should click into place.
Maintenance and care When to change the dust compartment filter (for motor protection) Replace this filter every time you start a new packet of dustbags. A dust compartment filter is supplied with every packet of Miele dustbags. How to change the dust compartment filter ^ Open the dust compartment lid. ^ Unclip the filter frame, remove the old filter and replace with a new one. ^ Close the filter frame. Downloaded From Vacuum-Manual.
Maintenance and care When to change the thread lifters The thread lifters on the suction inlet to the floorhead and the upholstery nozzle can be replaced. Check them from time to time and replace them if the pile has worn down. To replace the thread lifters ^ Use a knife or similar object to remove them from the slots. ^ Fit new thread lifters. If threads or hair have wound round the bearing on the floorhead roller a Use a coin to release the bearing (bayonet connection) and then pull it out.
Cleaning and care ,Always disconnect the vacuum cleaner from the electricity supply for maintenance work and for cleaning. Switch off at the wall socket and remove the plug. Vacuum cleaner and accessories External surfaces of the vacuum cleaner and of the accessories can be cleaned with a dry or a slightly damp cloth, or with a proprietary cleaner suitable for plastic. ,Do not use abrasive cleaners, glass cleaners or all-purpose cleaners.
Problem solving guide / After sales service The vacuum cleaner switches off automatically. A temperature limiter switches the vacuum cleaner off automatically if it gets too hot. This can occur if, for instance, large articles block the suction tube or when the filter bag is full or contains particles of fine dust. A heavily soiled exhaust or dust compartment filter can also be the cause of overheating. Switch the vacuum cleaner off immediately using the On/Off switch.
Optional accessories Miele accessories including floorheads, filters and dustbags are available to order from your Chartered Agent, the Miele Spare Parts Department or via the internet on www.miele-shop.com. Certain models are supplied as standard with one or more of the following accessories: Important: please observe the flooring manufacturer's cleaning and care instructions.
Optional accessories ALLERGOTEC -3 floorhead The level of cleanliness of the floor shows in a colour "traffic light" display when vacuuming. The ALLERGOTEC floorhead is designed specially for the daily hygienic cleaning of all floor surfaces. Floor brush -3 Special brush for cleaning hard floors (parquet, stone, PVC), and flooring which might be scratched, (e. g. with a high shine). Downloaded From Vacuum-Manual.
Optional accessories Universal brush For dusting books, shelves, etc. Radiator brush (Can only be used if attached to the crevice nozzle). For cleaning radiators, narrow shelves and crevices. Downloaded From Vacuum-Manual.
Optional accessories Mattress nozzle For cleaning upholstery, mattresses, cushions, curtains, covers etc. Crevice nozzle (300 mm) For cleaning in folds, crevices or corners. Hose adapter For extending the suction hose by approx. 1.5 m. The adapter is fitted between the hand piece and the suction hose. Downloaded From Vacuum-Manual.
Optional accessories Hygiene seal with active charcoal This prevents dust and odours from escaping when the suction hose is removed for transportation or storage. It can be secured to the suction hose during vacuuming. Micro Set This set is specially designed for cleaning small objects and difficult to reach areas (such as PC keyboards, stereo equipment, intricately carved furniture and ornaments, models etc).
Optional accessories Active Air Clean filter A special active charcoal filter, which removes odours coming from the dirt in the dustbag, keeping unpleasant lingering smells to a minimum. The Active Air Clean filter replaces the filter fitted in the vacuum cleaner. There is no difference in the filtration levels between the Active Air Clean filter and the Super Air Clean filter. Active HEPA filter A combination filter which complies to the requirements of EN 1822 HEPA Classification 12.
Electrical connection Electrical connection All work should be carried out by a suitably qualified and competent person in strict accordance with national and local safety regulations. The voltage connected load are given on the data plate located underneath the vacuum cleaner. Please ensure that these match the household mains supply. The fuse rating is quoted on the plug. The appliance is supplied with a cable and moulded plug ready for connection to a 230V/50Hz a.c. single phase supply. Test Marks.......
Alteration rights reserved / (710-718) - 1508 Downloaded From Vacuum-Manual.com Manuals M.-Nr.
