User manual

en
47
If you wish to fit an Active AirClean
50, AirClean Plus 50 or HEPA Air‐
Clean 50, see "Maintenance - Re‐
placing one type of exhaust filter
with another".
 Close the filter grille.
 Close the dust compartment lid.
Replacing the Active AirClean 50,
AirClean Plus 50 and HEPA AirClean
50 exhaust filters (dia. 35 + 36)
Do not use more than one exhaust fil‐
ter at a time.
 Open the dust compartment lid.
 Lift the exhaust filter and remove it.
 Insert a new exhaust filter making it
sure it goes in properly, then push it
down into position.
 Press the exhaust filter change indi‐
cator
(dia. 12).
After approx. 10 - 15 seconds a thin red
line will appear in the left hand side of
the display (dia. 13)
.
If you wish to fit an AirClean filter,
see "Maintenance - Replacing one
type of exhaust filter with another".
 Close the dust compartment lid.
Replacing one type of exhaust filter
with another (dia. 09)
Depending on model, your vacuum
clean
er w
ill be fitted as standard with
one of the following exhaust filters:
a AirClean
b Active AirClean 50 (black)
c AirClean Plus 50 (light blue)
d HEPA AirClean 50 (white)
Do not use more than one exhaust fil‐
ter at a time.
When changing the filter please note:
1. If you wish to replace exhaust filter a
with filter b
, c or d, it is essential that
you remove the filter grille before you
fit the new exhaust filter.
You must also activate the exhaust
filter chan
ge indicator (dia. 12).
2. If you wish to replace exhaust filter b,
c or d with filter
a, it is essential that
you also fit the filter grille * (dia. 34).
* Filter grille - see "Optional accesso‐
ries".
Maintenance indicator with reset
button
(dia. 37)
Some models are fitted with a mainte‐
nance indicator.
The indicator lights up after approx. 50
hours of operation, which is equivalent
to about a year of average use. The lev‐
el of soiling of the dust compartment fil‐
ter and the exhaust filter must be
checked at this point.
If the filters are replaced, the indicator
must be reset. To do this the vacuum
cleaner must be switched on.
 Press the reset button.
The maintenance indicator will go out
and reset to zero.