Technical information

Technical Information

T1302, T1303, T1322, T1329ci, T1323c,

T1403 and T1405 Clothes Dryers

4 Service

4.1 Drum Support Housing – Removal

Caution

To prevent damage to the Rear Drum Bearing, ensure the drum is

empty and no excess weight is placed on the drum while the drum

support housing is uninstalled from the appliance.

1. Remove the Lid (010 4.1).

2. Remove the Fascia Panel (060 4.4)

3. Remove the Electronic (060 4.5).

4. Remove the Fascia Panel frame.

5. Remove the Front Panel (010 4.3)

6. Remove the Fan Impeller (040 4.4)

7. Remove the Support Bracket (010 4.5)

8. Remove the screws from around the drum support housing.

9. Unclip the bulb holder.

10. Disconnect the connector for the Temperature Sensor.

11. Disconnect the cable from the Door Lock Button.

12. Slide the drum support housing upward to release the retainers

from the frame. Lift the drum support housing from the

appliance.

13. Reassemble by following these instructions in reverse order.

Reassembly Note

Ensure all locking tabs on drum support housing are fully engaged

in the frame before installing any retaining screws.