Operation Manual

Description of the machine
Programme sequence and check lights
Fault messages
Faults or interruptions are indicated by the
sequence lights or the check lights flashing.
The messages are:
Heating
Fault in the heating system.
Action: Please contact the Service department.
Safety period
The maximum running time of the drying
programme was exceeded because the
residual moisture at the start of the
programme was too high.
Action: Start the drying programme again.
If the fault message occurs again please call
the Service department.
Venting
The venting duct is blocked or badly restricted.
Action: Check the vent ducting and if
necessary clean it.
Fluff filter
The fluff filter is clogged.
Action: Clean the fluff filter at the end of the
programme.
Note:
The "Drying", "Cool air" and "Anti-crease/End"
indicator lights flash if there is a power cut or if
a programme has been interrupted (e.g. when
a door has been opened and shut). They are
not indicative of a fault. The lights will stop
flashing when the "Start" button is pressed
again.
Emergency Stop switch
Only use this switch in an emergency.
Do not use it in normal operation to switch the
machine off.
To reset the Emergency stop switch after it
has been used, turn the ribbed disk clockwise.
On
Drying
Cool air
Anti-crease/End
Check venting
Check fluff filter
9 «M.-Nr. 06 411 820 - GB - »