User manual

19
Connecting the Electrobrush
Depending on how you decide to con-
figure your vacuum cleaner, you can
connect either the PowerUnit connector
or the suction tube connector to the
Electrobrush.
 Push the connector into the Electro-
brush from above until it audibly
clicks into place.
 To separate the individual sections
from each other, press the release
catch on the Electrobrush and pull
the connector out of the Electro-
brush.
General battery information
The rechargeable battery is supplied
not fully charged.
Charge the battery completely before
using it for the first time. Allow approx-
imately 4hours for this.
It is essential to charge the battery for
the first time in the PowerUnit in order
to activate maximum power in the bat-
tery.
Once the battery is fully charged, the
battery charging state indicator
switches off to conserve energy.
You can use the vacuum cleaner for up
to 17minutes if you are using it in its
fully assembled state at the maximum
power level.
If, however, you are using the
PowerUnit on its own and select the
lowest power level, you can vacuum for
up to 60minutes.