User manual
Table Of Contents
- Contents
- Warning and Safety instructions
- Guide to the appliance
- Caring for the environment
- -
- Installation and connection
- Assembling the vacuum cleaner
- Using the PowerUnit solo
- Connecting the Comfort handle
- Connecting the PowerUnit and the suction tube
- Inserting the battery
- Connecting the Electrobrush
- General battery information
- Charging the battery (without wall mounting)
- Charging the battery (with wall mounting)
- Wall mounting
- Attaching the mounting plate
- Connecting the accessories holder (if required)
- Connecting the wall bracket
- Battery charging state indicator (while charging)
- Battery charging state indicator (while in use)
- Using the supplied accessories
- Use
- Maintenance
- Error messages
- Problem solving guide
- Cleaning and care
- Service
- Optional accessories
- Electrical connection for the UK
- Installation and connection
29
The cover at the bottom of the dust
container will open and the dust will fall
out.
Turn the lid of the dust container back
to its original position.
Close the cover making sure it clicks
into place.
Slide the dust container handle along
the guide line and down on to the
PowerUnit connector from above until
it audibly clicks into place.
Cleaning the fine dust filter
The fine dust filter is located in the dust
container.
Clean the fine dust filter at least once a
month.
Remove the dust container.
Lift the fine dust filter upwards to re-
move it.
Risk of damage caused by incor-
rect cleaning.
The fine dust filter can become dam-
aged and be less effective as a res-
ult.
Do not clean the inside of the fine
dust filter. Do not use pointed or
sharp-edged objects to clean the fil-
ter. Do not brush the fine dust filter.
Hold the fine dust filter over a bin.
Carefully knock the fine dust filter
with the rubberised lower edge.
Turn the fine dust filter slightly while
you do this to free the dirt from all of
the crevices.