User Guide and Installation Instruction

Installation and connection
78
Changing the door hinging
You can change the door hinging on
this tumble dryer yourself.
 For safety reasons, the tumble
dryer must be disconnected from the
electricity supply before changing
the door hinging.
You will need:
– a Torx T20 and T30 screwdriver
– a flat head screwdriver or pointed
pliers
– the lock catch cover supplied
– the door hinge cover supplied
– a soft surface (e.g., a blanket)
Changing the hinging over
1. Remove the door from the tumble
dryer
 Open the door.
 Use a T30 Torx screwdriver to
unscrew the two screws on the base
plate of the door hinge .
The door cannot fall off.
 Hold the door securely and pull it
forwards: to remove the door you will
need to pull the base plate of the
hinge with its 2 pins out of the dryer.
To avoid scratching the door, place it
outer side downwards on a soft
surface (e.g., a blanket).
2. Change over the door lock on the
dryer
 Use a Torx T30 screwdriver to
unscrew the two screws on the door
lock .
 Use the screwdriver to press the door
lock upwards.
The door lock will spring out of its
position and can then be removed.