Operating instructions/Installation instructions
Table Of Contents
- Contents
- Caring for the environment
- IMPORTANT SAFETY INSTRUCTIONS
- Operating the tumble dryer
- Energy-saving tips
- Functioning of the heat-pump dryer
- Initial set-up
- 1. Notes on correct laundry care
- 2. Loading the tumble dryer
- 3. Selecting a program and starting it
- 4. Removing the laundry at the end of the program
- Delay Start/SmartStart
- Program chart
- Changing the program sequence
- Condensed water container
- Fragrance flacon
- Cleaning and care
- Frequently Asked Questions
- Customer Service
- MIELE
- IMPORTANT SAFETY INSTRUCTIONS
- Installation
- Technical data
- Programmable functions
Cleaning and care
49
Cleaning the plinth-filter access
panel
Use a damp cloth to remove any lint.
Make sure that you do not damage
the rubber seal when doing this.
Close the heat-exchanger access
panel.
Damage or ineffective drying if
drying takes place without a plinth
filter or when the heat-exchanger
access panel is open.
An excessive accumulation of lint
can damage the tumble dryer. If the
system is not leak-tight, this can
make the drying ineffective.
Only operate the tumble dryer with
the plinth filter installed and the heat-
exchanger access panel closed.
Cleaning the dryer
Disconnect the tumble dryer from the
electrical supply.
Damage due to the use of
unsuitable care products.
Unsuitable care products could
damage plastic surfaces and other
parts.
Do not use any solvents, abrasive
cleaners, glass cleaners, or all-
purpose cleaners.
Clean the tumble dryer and the seal
on the inside of the door with a
slightly damp soft cloth and a mild
solution of liquid dish soap and water.
Dry all the parts with a soft cloth.