Operating instructions/Installation instructions
Table Of Contents
- Contents
- Caring for the environment
- IMPORTANT SAFETY INSTRUCTIONS
- Operating the tumble dryer
- Energy-saving tips
- Functioning of the heat-pump dryer
- Initial set-up
- 1. Notes on correct laundry care
- 2. Selecting a program
- 3. Loading the tumble dryer
- 4. Selecting program settings
- 5. Starting a program
- 6. Program end – removing the laundry
- Program chart
- Extra options
- Changing the program sequence
- Condensed water container
- Fragrance flacon
- Cleaning and care
- Frequently Asked Questions
- The display indicates messages or faults
- Unsatisfactory drying results
- The drying cycle duration is very long
- General problems with the tumble dryer
- Replacing the plinth filter
- Reactivating the plinth filter
- Checking the heat exchanger unit
- Cleaning the lint filter in the condensed water container
- Replacing the blocked spray jet for the Steam Care program
- Bottom right grille
- Customer Service
- MIELE
- IMPORTANT SAFETY INSTRUCTIONS
- Installation
- Technical data
- Settings
2. Selecting a program
26
Switching on the tumble dryer
The tumble dryer is switched on when
you select a program and switched off
by turning the program selector to the
position.
Turn the program selector to a pro-
gram.
When a program is selected, the pro-
gram name and the maximum load
(weight of dry laundry) possible for the
program will appear in the display for
a few seconds.
Selecting a program
There are three possible ways to select
a program.
1. Selecting standard programs with
the program selector
Turn the program selector to the re-
quired program.
The selected program will be shown in
the display. This will then be replaced
by the standard display.
Important: When selecting the
Soft Steam program, you must make
sure that the condensed water con-
tainer has been filled as described in
these operating instructions (see
“Condensed water container”).