Operating instructions/Installation instructions
Table Of Contents
- Contents
- Caring for the environment
- IMPORTANT SAFETY INSTRUCTIONS
- Operating the tumble dryer
- Energy-saving tips
- Functioning of the heat-pump dryer
- Initial set-up
- 1. Notes on correct laundry care
- 2. Selecting a program
- 3. Loading the tumble dryer
- 4. Selecting program settings
- 5. Starting a program
- 6. Program end – removing the laundry
- Program chart
- Extra options
- Changing the program sequence
- Condensed water container
- Fragrance flacon
- Cleaning and care
- Frequently Asked Questions
- The display indicates messages or faults
- Unsatisfactory drying results
- The drying cycle duration is very long
- General problems with the tumble dryer
- Replacing the plinth filter
- Reactivating the plinth filter
- Checking the heat exchanger unit
- Cleaning the lint filter in the condensed water container
- Replacing the blocked spray jet for the Steam Care program
- Bottom right grille
- Customer Service
- MIELE
- IMPORTANT SAFETY INSTRUCTIONS
- Installation
- Technical data
- Settings
Program chart
37
Smoothing Very small load (2.2lb/1kg)*
Normal, Hand Iron
Items - Cotton and linen fabric.
- For minimum iron items made of cotton, mixed, or synthetic fiber.
For example, pants, jackets, and shirts.
Tip - This program smoothes out creasing caused during the spin cycle
in the washing machine.
- This program is also suitable for dry fabrics.
- Please remove the garments as soon as the program has finished.
SoftSteam Very small load (2.2lb/1kg)*
Normal, Hand Iron
Items - All items made of cotton or linen fabric.
- For minimum iron items made of cotton, mixed, or synthetic fiber.
For example, pants, anoraks, and shirts.
Tip - For dampening the items before ironing.
- For smoothing items that are creased.
- Select Hand iron if the items are to be ironed after drying.
Note - At the beginning of the program, the condensed water collected in
the condensed water container is sprayed into the drum via a
spray jet. The condensed water container must therefore be filled
with water to at least the –min– marker.
- You can hear a humming noise during the spraying process.