Operating instructions/Installation instructions
Table Of Contents
- Contents
- Caring for the environment
- IMPORTANT SAFETY INSTRUCTIONS
- Operating the tumble dryer
- Energy-saving tips
- Functioning of the heat-pump dryer
- Initial set-up
- 1. Notes on correct laundry care
- 2. Selecting a program
- 3. Loading the tumble dryer
- 4. Selecting program settings
- 5. Starting a program
- 6. Program end – removing the laundry
- Program chart
- Extra options
- Changing the program sequence
- Condensed water container
- Fragrance flacon
- Cleaning and care
- Frequently Asked Questions
- The display indicates messages or faults
- Unsatisfactory drying results
- The drying cycle duration is very long
- General problems with the tumble dryer
- Replacing the plinth filter
- Reactivating the plinth filter
- Checking the heat exchanger unit
- Cleaning the lint filter in the condensed water container
- Replacing the blocked spray jet for the Steam Care program
- Bottom right grille
- Customer Service
- MIELE
- IMPORTANT SAFETY INSTRUCTIONS
- Installation
- Technical data
- Settings
Condensed water container
44
Emptying the condensed water
container
The condensed water is collected in
the condensed water container.
Empty the condensed water container
after every drying program.
When the maximum level in the con-
densed water container is reached, the
following message lights up in the dis-
play: Empty container See
To delete the message:
Open and close the door (with the
dryer switched on).
Remove the condensed water con-
tainer.
To prevent water from running out,
keep it in a horizontal position when
carrying it. Hold the condensed water
container at the front and towards the
back.
Empty the condensed water con-
tainer.
Replace the condensed water con-
tainer in the dryer.
It can cause health problems in peo-
ple and animals.
Do not drink condensed water.
The condensed water can be used for
the Soft Steam program. The con-
densed water container must be filled
to use this program (see the following
section).