Operating instructions/Installation instructions
Table Of Contents
- Contents
- Caring for the environment
- IMPORTANT SAFETY INSTRUCTIONS
- Operating the tumble dryer
- Energy-saving tips
- Functioning of the heat-pump dryer
- Initial set-up
- 1. Notes on correct laundry care
- 2. Selecting a program
- 3. Loading the tumble dryer
- 4. Selecting program settings
- 5. Starting a program
- 6. Program end – removing the laundry
- Program chart
- Extra options
- Changing the program sequence
- Condensed water container
- Fragrance flacon
- Cleaning and care
- Frequently Asked Questions
- The display indicates messages or faults
- Unsatisfactory drying results
- The drying cycle duration is very long
- General problems with the tumble dryer
- Replacing the plinth filter
- Reactivating the plinth filter
- Checking the heat exchanger unit
- Cleaning the lint filter in the condensed water container
- Replacing the blocked spray jet for the Steam Care program
- Bottom right grille
- Customer Service
- MIELE
- IMPORTANT SAFETY INSTRUCTIONS
- Installation
- Technical data
- Settings
Cleaning and care
50
Lint filters
This tumble dryer has 2 lint filters in
the door opening: the upper and lower
lint filters trap lint produced during the
drying process.
Clean the lint filters after each drying
program. This prevents an extension
of the program duration.
Also clean the lint filters when this
message appears in the display: Clean
the lint and plinth filters. See the Operating
Instructions for more information.
To delete the message:
Confirm with OK.
Removing the fragrance flacon
The intensity of the fragrance will be re-
duced if the lint filters and plinth filter
are not cleaned.
Remove the fragrance flacon. See
“Fragrance flacon”, “Removing/re-
placing the fragrance flacon”.
Removing visible lint
Tip: You can also use a vacuum cleaner
so that you can remove the lint without
touching it.
Open the door.
Pull the upper lint filter forward to re-
move it.
Remove the lint (see arrows).