Operating instructions/Installation instructions
Table Of Contents
- Contents
- Caring for the environment
- IMPORTANT SAFETY INSTRUCTIONS
- Operating the tumble dryer
- Energy-saving tips
- Functioning of the heat-pump dryer
- Initial set-up
- 1. Notes on correct laundry care
- 2. Selecting a program
- 3. Loading the tumble dryer
- 4. Selecting program settings
- 5. Starting a program
- 6. Program end – removing the laundry
- Program chart
- Extra options
- Changing the program sequence
- Condensed water container
- Fragrance flacon
- Cleaning and care
- Frequently Asked Questions
- The display indicates messages or faults
- Unsatisfactory drying results
- The drying cycle duration is very long
- General problems with the tumble dryer
- Replacing the plinth filter
- Reactivating the plinth filter
- Checking the heat exchanger unit
- Cleaning the lint filter in the condensed water container
- Replacing the blocked spray jet for the Steam Care program
- Bottom right grille
- Customer Service
- MIELE
- IMPORTANT SAFETY INSTRUCTIONS
- Installation
- Technical data
- Settings
Frequently Asked Questions
58
Message Possible cause and solution
Clean plinth filter.
See lights up
after a program
has been can-
celed.
The system has been clogged by lint or detergent
residue.
To switch off the message: press OK.
Clean the lint filters and the plinth filter.
Please see “Cleaning and care” for notes on clean-
ing.
Check that the lint filters and the plinth filter are
not damaged or worn.
If all lint filters are damaged, deformed, or cannot be
cleaned anymore, they must be replaced. For infor-
mation on when to replace a plinth filter that is not
functioning properly, refer to “Frequently Asked
Questions – Replacing the plinth filter”.
Clean plinth filter.
See continues
to light up after a
program has
been canceled,
despite thorough
cleaning.
The plinth filter looks clean after thorough cleaning.
However, the program terminates and the fault mes-
sage appears again. It is likely that there is still un-
derlying residue that could not be removed.
To switch off the message: press OK.
Check for the possible causes described below.
The heat exchanger is clogged.
Check the heat exchanger. Follow the instructions
described in “Frequently Asked Questions –
Checking the heat exchanger”.
The plinth filter is clogged further down.
Check the plinth filter. Follow the instructions de-
scribed in “Frequently Asked Questions – Replac-
ing the plinth filter”.
If the plinth filter is not deformed or defective, you
can reactivate it in the washing machine. Follow
the instructions described in “Frequently Asked
Questions – Reactivating the plinth filter”.