Operating instructions/Installation instructions
Table Of Contents
- Contents
- Caring for the environment
- IMPORTANT SAFETY INSTRUCTIONS
- Operating the tumble dryer
- Energy-saving tips
- Functioning of the heat-pump dryer
- Initial set-up
- 1. Notes on correct laundry care
- 2. Selecting a program
- 3. Loading the tumble dryer
- 4. Selecting program settings
- 5. Starting a program
- 6. Program end – removing the laundry
- Program chart
- Extra options
- Changing the program sequence
- Condensed water container
- Fragrance flacon
- Cleaning and care
- Frequently Asked Questions
- The display indicates messages or faults
- Unsatisfactory drying results
- The drying cycle duration is very long
- General problems with the tumble dryer
- Replacing the plinth filter
- Reactivating the plinth filter
- Checking the heat exchanger unit
- Cleaning the lint filter in the condensed water container
- Replacing the blocked spray jet for the Steam Care program
- Bottom right grille
- Customer Service
- MIELE
- IMPORTANT SAFETY INSTRUCTIONS
- Installation
- Technical data
- Settings
Frequently Asked Questions
59
Message Possible cause and solution
Empty container See
lights up after
a program has
been canceled.
The condensed water container is full or there is a
kink in the drain hose.
Empty out the condensed water container.
Check the drain hose.
To switch the fault message off:
Open and close the door while the dryer is
switched on or switch the dryer off and back on
again.
Soft Steam
This is to remind you that water is taken from the
condensed water container when the Soft Steam pro-
gram is being used. The condensed water container
must be filled with water to at least the –min–
marker.
Fill the condensed water container.
To switch off the message:
Confirm with OK.
Open & close door
This it to remind you to load the laundry when the
SoftSteam program is selected.
Load the laundry in the drum.
Blockage detected.
See lights up
after a program
has been inter-
rupted.
The laundry is unevenly distributed or has rolled up.
Open the door and untangle the laundry, and re-
move a few items, if necessary.
Switch the dryer off and then on again.
Start a program.
Service Fault F
XXX lights up af-
ter a program
has been inter-
rupted.
There is no obvious cause.
Switch the dryer off and then on again.
Start a program.
If the program is interrupted again and an error mes-
sage appears, there is a fault. Contact Miele Service.