Operating instructions/Installation instructions
Table Of Contents
- Contents
- Caring for the environment
- IMPORTANT SAFETY INSTRUCTIONS
- Operating the tumble dryer
- Energy-saving tips
- Functioning of the heat-pump dryer
- Initial set-up
- 1. Notes on correct laundry care
- 2. Selecting a program
- 3. Loading the tumble dryer
- 4. Selecting program settings
- 5. Starting a program
- 6. Program end – removing the laundry
- Program chart
- Extra options
- Changing the program sequence
- Condensed water container
- Fragrance flacon
- Cleaning and care
- Frequently Asked Questions
- The display indicates messages or faults
- Unsatisfactory drying results
- The drying cycle duration is very long
- General problems with the tumble dryer
- Replacing the plinth filter
- Reactivating the plinth filter
- Checking the heat exchanger unit
- Cleaning the lint filter in the condensed water container
- Replacing the blocked spray jet for the Steam Care program
- Bottom right grille
- Customer Service
- MIELE
- IMPORTANT SAFETY INSTRUCTIONS
- Installation
- Technical data
- Settings
Frequently Asked Questions
61
The drying cycle duration is very long
Problem Possible cause and solution
The drying process
goes on too long or
even switches off.*
The room where the tumble dryer is located is too
warm.
Ventilate the room thoroughly.
Detergent residue, hair, and fine lint can clog the fil-
ters.
Clean the lint filters and the plinth filter.
Remove visible lint
– at the bottom left, behind the panel in the heat
exchanger cavity (see “Cleaning and care”)
– at the bottom right of the cooling fins behind the
grille (see the end of this section)
The laundry is unevenly distributed or has rolled up.
The drum is too full.
Untangle the laundry and remove a few items.
Start a program.
The cool air intake (bottom right grille) is blocked.
Move any objects, such as a laundry basket, away
from the dryer.
The laundry is too damp.
Spin using a higher spin speed in the washing ma-
chine.
Metallic components, e.g., zippers, have prevented
the dryer from registering the correct moisture level.
Open the zippers next time.
If the problem recurs, dry these items using the
Time Dry program.
* Switch the tumble dryer off and on again before starting a new program.