Operating instructions/Installation instructions
Table Of Contents
- Contents
- Caring for the environment
- IMPORTANT SAFETY INSTRUCTIONS
- Operating the tumble dryer
- Energy-saving tips
- Functioning of the heat-pump dryer
- Initial set-up
- 1. Notes on correct laundry care
- 2. Selecting a program
- 3. Loading the tumble dryer
- 4. Selecting program settings
- 5. Starting a program
- 6. Program end – removing the laundry
- Program chart
- Extra options
- Changing the program sequence
- Condensed water container
- Fragrance flacon
- Cleaning and care
- Frequently Asked Questions
- The display indicates messages or faults
- Unsatisfactory drying results
- The drying cycle duration is very long
- General problems with the tumble dryer
- Replacing the plinth filter
- Reactivating the plinth filter
- Checking the heat exchanger unit
- Cleaning the lint filter in the condensed water container
- Replacing the blocked spray jet for the Steam Care program
- Bottom right grille
- Customer Service
- MIELE
- IMPORTANT SAFETY INSTRUCTIONS
- Installation
- Technical data
- Settings
Frequently Asked Questions
62
General problems with the tumble dryer
Problem Possible cause and solution
You can hear operating
noises (buzzing/hum-
ming).
This is not a fault.
The compressor (heat pump) is operating.
No action required. These noises are quite normal
and can be heard when the compressor is operat-
ing.
A program does not
start.
There is no obvious cause.
Connect the power plug.
Turn on the tumble dryer.
Close the door.
Check whether the fuse has tripped.
Power outage? When power is restored, any previ-
ously running program will restart automatically.
The display is off and
the Start/Add laundry
sensor button is flash-
ing slowly.
The display has switched off automatically to save
energy (Standby mode).
The drum will turn at intervals in the Anti-crease
phase.
Press any button. This switches Standby off.
The tumble dryer is
switched off at the end
of the program.
The tumble dryer switches off automatically. This is
not a fault, but a normal function.
The display is in a dif-
ferent language.
A different language has been selected in “Settings,
Language ”.
Set the language you want. The flag symbol will
guide you.
The interior drum light-
ing does not come on.
Not a fault. The drum lighting switches off automati-
cally in the following cases:
If the door is closed.
If the door remains open for an extended period of
time.