Operating instructions/Installation instructions
Table Of Contents
- Contents
- Caring for the environment
- IMPORTANT SAFETY INSTRUCTIONS
- Operating the tumble dryer
- Energy-saving tips
- Functioning of the heat-pump dryer
- Initial set-up
- 1. Notes on correct laundry care
- 2. Selecting a program
- 3. Loading the tumble dryer
- 4. Selecting program settings
- 5. Starting a program
- 6. Program end – removing the laundry
- Program chart
- Extra options
- Changing the program sequence
- Condensed water container
- Fragrance flacon
- Cleaning and care
- Frequently Asked Questions
- The display indicates messages or faults
- Unsatisfactory drying results
- The drying cycle duration is very long
- General problems with the tumble dryer
- Replacing the plinth filter
- Reactivating the plinth filter
- Checking the heat exchanger unit
- Cleaning the lint filter in the condensed water container
- Replacing the blocked spray jet for the Steam Care program
- Bottom right grille
- Customer Service
- MIELE
- IMPORTANT SAFETY INSTRUCTIONS
- Installation
- Technical data
- Settings
Frequently Asked Questions
67
Replacing the blocked spray
jet for the Steam Care program
Limescale deposits will impair the
spray jet.
In this case, the spray jet must be re-
moved and replaced with a new one
(see “Optional accessories”).
You can only replace the spray jet us-
ing a special tool. The special tool is
supplied with the new spray jet.
Using the wrong tool can cause
damage.
Doing so can damage the spray jet
or the tumble dryer.
Only use the tool supplied. Do not
use any other tool.
The Steam Care program must never
be used without the spray jet in-
stalled and screwed in correctly.
Open the door of the tumble dryer.
The spray jet is located in the top left of
the door opening.
Attach the tool to the spray jet.
Turn the tool counterclockwise to un-
screw the spray jet.
Insert the new spray jet in the tool.
Turn the tool clockwise to screw the
spray jet securely in position.