Operating instructions/Installation instructions
Table Of Contents
- Contents
- Caring for the environment
- IMPORTANT SAFETY INSTRUCTIONS
- Operating the tumble dryer
- Energy-saving tips
- Functioning of the heat-pump dryer
- Initial set-up
- 1. Notes on correct laundry care
- 2. Selecting a program
- 3. Loading the tumble dryer
- 4. Selecting program settings
- 5. Starting a program
- 6. Program end – removing the laundry
- Program chart
- Extra options
- Changing the program sequence
- Condensed water container
- Fragrance flacon
- Cleaning and care
- Frequently Asked Questions
- The display indicates messages or faults
- Unsatisfactory drying results
- The drying cycle duration is very long
- General problems with the tumble dryer
- Replacing the plinth filter
- Reactivating the plinth filter
- Checking the heat exchanger unit
- Cleaning the lint filter in the condensed water container
- Replacing the blocked spray jet for the Steam Care program
- Bottom right grille
- Customer Service
- MIELE
- IMPORTANT SAFETY INSTRUCTIONS
- Installation
- Technical data
- Settings
Installation
*INSTALLATION*
79
Electrical connection
GROUNDING INSTRUCTIONS
The electrical safety of this dryer can
only be guaranteed when continuity
is complete between it and an effec-
tive grounding system. It is essential
that this standard safety requirement
is observed and regularly tested. If in
any doubt, please have the electrical
installation inspected by a qualified
electrician. Miele cannot be held li-
able for the consequences of an in-
adequate grounding system. The
electrical socket must be easily ac-
cessible so that the dryer can be dis-
connected from the electricity sup-
ply.
WARNING – If the grounding con-
ductor is connected incorrectly, this
can result in electric shock. Contact
a qualified electrician if you are un-
sure whether the appliance is prop-
erly grounded.
Do not change the plug: If it does not
fit into the socket, you should have a
proper outlet installed by a qualified
electrician.
The dryer is equipped with a power
cord 6'7" (2m) with plug. The dryer is
connected to a NEMA 5-15 socket with
an electrical connection of 120V,
60Hz, 15A.
The manufacturer recommends operat-
ing the appliance on a dedicated circuit
to avoid overloading the electrical cir-
cuit.
Connection adapter for NEMA 14-30
socket
If a NEMA 14-30 socket is pro-
vided on-site for the dryer, the Miele
connection adapter* can be used.
Observe the following description to
avoid damage to the dryer.
Tip: * You can order the connection
adapter directly from Miele (USA or
CDN).
- The connection adapter has a NEMA
14-30 plug and two NEMA 5-15
socket-side connectors. The dryer
and washing machine can therefore
be connected to the 120V/60Hz
electricity supply.
- The connection adapter is equipped
with two 15A fuses which protect
both the connected appliances and
the connection adapter.