Operating instructions/Installation instructions
Table Of Contents
- Contents
- Caring for the environment
- IMPORTANT SAFETY INSTRUCTIONS
- Operating the tumble dryer
- Energy-saving tips
- Functioning of the heat-pump dryer
- Initial set-up
- 1. Notes on correct laundry care
- 2. Selecting a program
- 3. Loading the tumble dryer
- 4. Selecting program settings
- 5. Starting a program
- 6. Program end – removing the laundry
- Program chart
- Extra options
- Changing the program sequence
- Condensed water container
- Fragrance flacon
- Cleaning and care
- Frequently Asked Questions
- The display indicates messages or faults
- Unsatisfactory drying results
- The drying cycle duration is very long
- General problems with the tumble dryer
- Replacing the plinth filter
- Reactivating the plinth filter
- Checking the heat exchanger unit
- Cleaning the lint filter in the condensed water container
- Replacing the blocked spray jet for the Steam Care program
- Bottom right grille
- Customer Service
- MIELE
- IMPORTANT SAFETY INSTRUCTIONS
- Installation
- Technical data
- Settings
Settings
91
Conductivity
This setting is only relevant for regions
with very soft water.
Very soft water can result in unsatis-
factory drying results.
You should only select this setting if
the water used for washing the laun-
dry is extremely soft with a conduc-
tivity reading (electrical conductivity)
less than 150μS/cm. Contact your
local water supplier for the conduc-
tivity level of your water supply.
Options
- Normal (default setting)
- low <150ms (only for regions with very
soft water)
Code
The PIN code prevents your dryer be-
ing used without your knowledge.
Options
- Activate
The code is 250 and can be acti-
vated.
When the code has been activated,
you have to enter the code after
switching the dryer on. Otherwise,
the dryer cannot be operated.
- Deactivate
For using the dryer without entering
the code. This only appears if the PIN
code has been activated previously.
- Change
You can enter a PIN code of your
own.
Make a note of the new PIN
code. If you forget the code, the
dryer will need to be unlocked by
Miele Customer Service.
Brightness
The display and the sensor button
lighting is switched off to save energy.
The Start/Stop sensor button flashes
slowly.
Options
Display
Controls the brightness of the display.
- (dark)
- (default setting)
- (light)
Buttons active
Controls the brightness of the activated
sensor buttons.
- (dark)
- (light)
Buttons inactive
Controls the brightness of the sensor
buttons that can be activated.
- (dark) (default setting)
- (light)
Tip: Ensure that there is a big differ-
ence in brightness between the acti-
vated and dimmed sensor buttons. This
makes it easier to operate the dryer.