Operating instructions/Installation instructions
Table Of Contents
- Contents
- Caring for the environment
- IMPORTANT SAFETY INSTRUCTIONS
- Operating the tumble dryer
- Energy-saving tips
- Functioning of the heat-pump dryer
- Initial set-up
- 1. Notes on correct laundry care
- 2. Selecting a program
- 3. Loading the tumble dryer
- 4. Selecting program settings
- 5. Starting a program
- 6. Program end – removing the laundry
- Program chart
- Extra options
- Changing the program sequence
- Condensed water container
- Fragrance flacon
- Cleaning and care
- Frequently Asked Questions
- The display indicates messages or faults
- Unsatisfactory drying results
- The drying cycle duration is very long
- General problems with the tumble dryer
- Replacing the plinth filter
- Reactivating the plinth filter
- Checking the heat exchanger unit
- Cleaning the lint filter in the condensed water container
- Replacing the blocked spray jet for the Steam Care program
- Bottom right grille
- Customer Service
- MIELE
- IMPORTANT SAFETY INSTRUCTIONS
- Installation
- Technical data
- Settings
Settings
94
Remote control
The Remote control setting is only visi-
ble if the Miele@home setting is set up
and activated.
Once the Miele@mobile app has been
installed on your mobile device, you
can check the status of your tumble
dryer from anywhere and start it re-
motely. You can also control it re-
motely via the MobileStart function.
You can switch off the Remote control
setting if you do not want to operate the
dryer with your mobile device.
If Remote control is not switched on, the
app can cause the program to be can-
celed.
Use the “delay start” button to set a
time at which you wish to start the tum-
ble dryer and start the delay start (see
“Delay start/SmartStart”).
The tumble dryer will then start within
the timeframe specified when it receives
your signal.
If it has not received a start signal by
the latest start time set, the tumble
dryer will start automatically.
Remote control is activated by default.
SmartGrid
The Remote control setting is only visi-
ble if the Miele@home setting is set up
and activated.
This function can be used for starting
your tumble dryer automatically at a
time when your energy costs are most
economical.
Activating SmartGrid, gives the delay
start button a new function. You set the
SmartGrid via the “delay start” button.
The tumble dryer will then start within
the timeframe specified when it receives
a signal from the energy supplier. If it
has not received a signal from the en-
ergy supplier by the latest start time set,
the tumble dryer will start automatically
(see “Delay start”). Please check with
your local utility provider for availability.
The SmartGrid function is switched off
by default.