Operation Manual
Table Of Contents
- Contents
- Caring for our environment 2
- Warning and Safety instructions 6
- Operating the washing machine 13
- Before using for the first time 15
- Washing environmentally and economically 16
- How to wash correctly 17
- Spinning 22
- Programme chart 23
- Extras 26
- Garment care label symbols 27
- Programme sequence 28
- Changing the programme sequence 30
- Detergent 32
- Cleaning and care 36
- Problem solving guide 39
- The programme does not start 39
- The following fault messages appear in the display and the programme stops 40
- The following fault messages appear in the display at the end of the programme 41
- General problems 42
- An unsatisfactory wash result 43
- The drum door does not open when you press the Door button 44
- Opening the drum door in the event of a blocked drain outlet and/or power failure 45
- After sales service 47
- Installation and connection 48
- Consumption data 59
- Technical data 60
- Programmable functions 61
- To access programmable functions 61
- To select a programmable function 61
- To alter a programmable function 61
- To come out of programmable functions 61
- Language ! 61
- Water plus 62
- Gentle action 62
- Suds cooling 62
- Code 63
- Temperature unit 64
- Buzzer 64
- Keypad tone 64
- Brightness 64
- Contrast 64
- Standby display 65
- Memory 65
- Anti-crease 65
- Optional accessories 66
Before using the machine for the first
time ensure that it is correctly
installed and connected. See
"Installation and connection". Also
check that the drain filter is securely
tightened to prevent the risk of water
leaks during use.
This washing machine has
undergone a thorough functional test
in the factory and there will be some
residual water in the drum from this
process.
For safety reasons, spinning is not
possible until the machine has been
prepared for using for the first time. To
activate the spinning function you must
run a wash programme without laundry
and without detergent.
Using detergent could result in an
excessive build-up of foam.
This also activates the ball valve. The
ball valve prevents detergent escaping
from the suds container into the sump
during a wash programme, thus making
maximum use of the detergent.
^
Press the _ button in.
If the washing machine is being
switched on for the first time, the
welcome screen will appear.
The welcome screen will appear in
the display every time the machine is
switched on until a programme
lasting longer than 1 hour has been
completed.
Setting the language
You will be asked to select the
language you require for the display. It
is possible to change the language at
any time via the programmable
functions.
! deutsch
^
If the language shown is not the one
you want, select the language you do
want by turning the programme
selector. Confirm your selection by
pressing the Start/Stop button.
Reminder to remove transit bars
To avoid the risk of damage, the
transit bars must be removed before
the machine is used for the first time.
See "Installation and connection" for
instructions on how to do this.
^ After removing the transit bars (if this
has not already been done by your
fitter), press the Start/Stop button.
Running your first programme
Run the Cottons r programme
without any laundry and without
detergent.
^
Open the stopcock.
^
Press the Start/Stop button.
^
At the end of the programme switch
the machine off.
The machine is now ready for use.
Before using for the first time
15