Operation Manual
Table Of Contents
- Contents
- Caring for our environment 2
- Warning and Safety instructions 6
- Operating the washing machine 13
- Before using for the first time 15
- Washing environmentally and economically 16
- How to wash correctly 17
- Spinning 22
- Programme chart 23
- Extras 26
- Garment care label symbols 27
- Programme sequence 28
- Changing the programme sequence 30
- Detergent 32
- Cleaning and care 36
- Problem solving guide 39
- The programme does not start 39
- The following fault messages appear in the display and the programme stops 40
- The following fault messages appear in the display at the end of the programme 41
- General problems 42
- An unsatisfactory wash result 43
- The drum door does not open when you press the Door button 44
- Opening the drum door in the event of a blocked drain outlet and/or power failure 45
- After sales service 47
- Installation and connection 48
- Consumption data 59
- Technical data 60
- Programmable functions 61
- To access programmable functions 61
- To select a programmable function 61
- To alter a programmable function 61
- To come out of programmable functions 61
- Language ! 61
- Water plus 62
- Gentle action 62
- Suds cooling 62
- Code 63
- Temperature unit 64
- Buzzer 64
- Keypad tone 64
- Brightness 64
- Contrast 64
- Standby display 65
- Memory 65
- Anti-crease 65
- Optional accessories 66

d = Low water level
( = Medium water level
e = High water level
a = Intensive rhythm
b = Normal rhythm
c = Gentle rhythm
d = Sensitive rhythm
e = Ultra sensitive rhythm
f = Handwash rhythm
This machine has fully electronic
controls with automatic load
recognition. It takes in the right amount
of water required for the programme
depending on the amount of laundry
and its absorbency rate. This means
that programme cycles and durations
can vary.
The programme sequences outlined in
the chart are based on the basic
programme with a full load. Extra
options which can be selected have not
been taken into account.
The display shows the stage the
programme has reached.
Special features in the programme
sequences:
Anti-crease:
At the end of the programme, the drum
continues to turn at intervals for up to
30 minutes to help prevent creasing.
Exception
: There is no anti-crease
phase in the Woollens programme.
The door can be opened and laundry
removed at any time during the anti-
crease phase.
1)
A second rinse is carried out when a
temperature between 60°C and 90°C
has been selected. A third rinse is
carried out when a temperature
below 60°C is selected.
2)
An third or fourth rinse is carried out
if:
– there is too much foam in the drum
– a spin speed lower than 700 rpm has
been selected
– No . has been selected.
3)
A third rinse is carried out if:
No . has been selected.
Programme sequence
29