Operation Manual
Table Of Contents
- Contents
- Caring for our environment 2
- Warning and Safety instructions 6
- Operating the washing machine 13
- Before using for the first time 15
- Washing environmentally and economically 16
- How to wash correctly 17
- Spinning 22
- Programme chart 23
- Extras 26
- Garment care label symbols 27
- Programme sequence 28
- Changing the programme sequence 30
- Detergent 32
- Cleaning and care 36
- Problem solving guide 39
- The programme does not start 39
- The following fault messages appear in the display and the programme stops 40
- The following fault messages appear in the display at the end of the programme 41
- General problems 42
- An unsatisfactory wash result 43
- The drum door does not open when you press the Door button 44
- Opening the drum door in the event of a blocked drain outlet and/or power failure 45
- After sales service 47
- Installation and connection 48
- Consumption data 59
- Technical data 60
- Programmable functions 61
- To access programmable functions 61
- To select a programmable function 61
- To alter a programmable function 61
- To come out of programmable functions 61
- Language ! 61
- Water plus 62
- Gentle action 62
- Suds cooling 62
- Code 63
- Temperature unit 64
- Buzzer 64
- Keypad tone 64
- Brightness 64
- Contrast 64
- Standby display 65
- Memory 65
- Anti-crease 65
- Optional accessories 66
With the help of the following notes, minor faults in the performance of the
machine, some of which may result from incorrect operation, can be put right
without contacting the Service Department.
,
Repair work to electrical appliances should only be carried out by a
suitably qualified person in strict accordance with current local and national
safety regulations. Repairs and other work by unqualified persons could be
dangerous. The manufacturer cannot be held liable for unauthorised work.
The programme does not start
Problem Possible cause Remedy
The display remains
dark, and the Start/
Stop button indicator
light does not come
on.
There is no power to
the machine.
Check whether
– the mains plug is plugged
in and switched on.
– the fuse or circuit breaker
has tripped.
You are asked to enter
a code.
Access via a code has
been activated.
Enter the code and confirm
the entry. Deactivate the code
if you do not wish this
message to appear in the
display the next time the
machine is switched on.
The display is dark. The display has
switched off
automatically to save
energy (Standby
mode).
Press a button. Standby
comes to an end.
Problem solving guide
39