Operation Manual
Table Of Contents
- Contents
- Caring for our environment 2
- Warning and Safety instructions 6
- Operating the washing machine 13
- Before using for the first time 15
- Washing environmentally and economically 16
- How to wash correctly 17
- Spinning 22
- Programme chart 23
- Extras 26
- Garment care label symbols 27
- Programme sequence 28
- Changing the programme sequence 30
- Detergent 32
- Cleaning and care 36
- Problem solving guide 39
- The programme does not start 39
- The following fault messages appear in the display and the programme stops 40
- The following fault messages appear in the display at the end of the programme 41
- General problems 42
- An unsatisfactory wash result 43
- The drum door does not open when you press the Door button 44
- Opening the drum door in the event of a blocked drain outlet and/or power failure 45
- After sales service 47
- Installation and connection 48
- Consumption data 59
- Technical data 60
- Programmable functions 61
- To access programmable functions 61
- To select a programmable function 61
- To alter a programmable function 61
- To come out of programmable functions 61
- Language ! 61
- Water plus 62
- Gentle action 62
- Suds cooling 62
- Code 63
- Temperature unit 64
- Buzzer 64
- Keypad tone 64
- Brightness 64
- Contrast 64
- Standby display 65
- Memory 65
- Anti-crease 65
- Optional accessories 66
The following fault messages appear in the display and the
programme stops
Fault message Possible cause Remedy A
;
Drain
fault
–
The water outlet is
blocked or restricted.
–
The drain hose has
been fixed too high.
–
Clean the drain filter and
the drain pump.
–
The maximum delivery head
is1m.
;
Water inlet
fault
The water inlet is blocked
or restricted.
Check whether
–
the stopcock is opened
properly.
–
the inlet hose is kinked.
– the water pressure is too
low.
The filter in the water inlet
hose is dirty.
Clean the filter.
;
Waterproof
fault
The water protection
system has reacted.
– Close the stopcock.
– Call the Service
Department.
;
Technical
fault
There is a fault. Start the programme again.
If the fault message appears
again, contact the Service
Department.
A To switch off the fault message: Switch the machine off with the _ button.
Problem solving guide
40