Operation Manual
Table Of Contents
- Contents
- Caring for our environment 2
- Warning and Safety instructions 6
- Operating the washing machine 13
- Before using for the first time 15
- Washing environmentally and economically 16
- How to wash correctly 17
- Spinning 22
- Programme chart 23
- Extras 26
- Garment care label symbols 27
- Programme sequence 28
- Changing the programme sequence 30
- Detergent 32
- Cleaning and care 36
- Problem solving guide 39
- The programme does not start 39
- The following fault messages appear in the display and the programme stops 40
- The following fault messages appear in the display at the end of the programme 41
- General problems 42
- An unsatisfactory wash result 43
- The drum door does not open when you press the Door button 44
- Opening the drum door in the event of a blocked drain outlet and/or power failure 45
- After sales service 47
- Installation and connection 48
- Consumption data 59
- Technical data 60
- Programmable functions 61
- To access programmable functions 61
- To select a programmable function 61
- To alter a programmable function 61
- To come out of programmable functions 61
- Language ! 61
- Water plus 62
- Gentle action 62
- Suds cooling 62
- Code 63
- Temperature unit 64
- Buzzer 64
- Keypad tone 64
- Brightness 64
- Contrast 64
- Standby display 65
- Memory 65
- Anti-crease 65
- Optional accessories 66
General problems
Problem Possible cause Remedy
The machine shakes
during the spin cycle.
The machine feet are not
level.
Level the machine (see
"Installation and
connection").
The laundry has not been
spun properly and is still
wet.
The machine detected an
imbalance during the final
spin and reduced the
spin speed automatically.
Include both large and
small items in the load as
this will give better
distribution.
The laundry has not spun
satisfactorily.
The spin speed selected
was too low.
Select a higher spin
speed next time.
The pump makes strange
noises.
This is not a fault! These noises occur at the end of a
pump sequence as a normal part of the operation.
There is a lot of
detergent residue in the
detergent drawer.
The water pressure is too
low.
– Clean the water inlet
filter.
– Select Water plus.
Powder detergent used
with water softeners can
be sticky.
Add washing powder
and then add the water
softener.
Fabric conditioner is not
completely dispensed or
too much water remains
in the § compartment.
The siphon tube is not
correctly positioned or is
clogged up.
Clean the siphon, (see
"Cleaning and care -
Cleaning the detergent
dispenser drawer").
The display is in a
different language.
A different language has
been selected in the
Programmable functions
- Language
!.
Set the language you
want. The flag symbol
will guide you.
When laundry is dry, it
feels hard to the touch.
Too vigorous wash action. Programme in gentle
action and more water.
Not enough detergent
used.
Increase detergent dose
to prevent limescale
build-up in laundry.
No fabric conditioner
used
Use fabric conditioner in
last rinse.
Problem solving guide
42