Operation Manual
Table Of Contents
- Contents
- Caring for our environment 2
- Warning and Safety instructions 6
- Operating the washing machine 13
- Before using for the first time 15
- Washing environmentally and economically 16
- How to wash correctly 17
- Spinning 22
- Programme chart 23
- Extras 26
- Garment care label symbols 27
- Programme sequence 28
- Changing the programme sequence 30
- Detergent 32
- Cleaning and care 36
- Problem solving guide 39
- The programme does not start 39
- The following fault messages appear in the display and the programme stops 40
- The following fault messages appear in the display at the end of the programme 41
- General problems 42
- An unsatisfactory wash result 43
- The drum door does not open when you press the Door button 44
- Opening the drum door in the event of a blocked drain outlet and/or power failure 45
- After sales service 47
- Installation and connection 48
- Consumption data 59
- Technical data 60
- Programmable functions 61
- To access programmable functions 61
- To select a programmable function 61
- To alter a programmable function 61
- To come out of programmable functions 61
- Language ! 61
- Water plus 62
- Gentle action 62
- Suds cooling 62
- Code 63
- Temperature unit 64
- Buzzer 64
- Keypad tone 64
- Brightness 64
- Contrast 64
- Standby display 65
- Memory 65
- Anti-crease 65
- Optional accessories 66
Connection to the water
supply
The machine should be connected to a
mains water supply in accordance with
local and national safety regulations.
The German authorities do not require it
to have a non-return valve as the
washing machine has been designed
to comply with DIN regulations.
The machine is designed to operate
with a flow pressure of between
100 kPa and 1,000 kPa. If it is higher
than 1,000 kPa it is essential to fit a
pressure reducing valve.
Connection to the mains water supply
should incorporate a mains stopcock
with
3
/
4
" thread. The stopcock should
be fitted by a qualified plumber.
,
The connection point is subject
to mains water pressure. Turn on the
stopcock slowly and check for leaks.
Correct the position of the washer
and union if appropriate.
The washing machine is not suitable
for connection to a hot water supply.
Maintenance and care
Only use a genuine Miele hose should
you ever need a replacement or
extension. These are tested to
withstand pressure of at least
7,000 kPa.
In order to protect the water inlet
valve, the two dirt filters - one in the
open end of the inlet hose, one at
the inlet point in the machine - must
not be removed.
Extension hose
–
Longer hoses 2.5 or 4.0 m in length
are available from your Miele dealer
or the Miele Spare Parts Department
as optional extras.
Installation and connection
56