Operation Manual

Adding stain remover
When Automatic dispensing is
selected, the i and j compartments
of the detergent dispenser drawer are
not flushed through with water.
If you want to add stain remover, either
1. Fill a detergent dispensing ball with
stain remover and place the ball in
the drum with the laundry.
or
2. Deactivate Automatic dispensing.
Add both detergent and stain
remover to the detergent dispenser
drawer.
Adding fabric conditioner or liquid
starch
Add fabric conditioner and liquid starch
to compartment §. The agent will be
dispensed with the final rinse.
B. Detergent dispenser drawer
Please note:
The percentage amounts in the display
will help you to add the correct
percentage amount of detergent
recommended by the manufacturer.
The percentage shown relates to the
amount of detergent recommended by
the manufacturer on the packaging.
50% = Add half the amount
recommended
60% = Add slightly more than half
the amount recommended
75% = Add three quarters of the
amount recommended
100% = Add the full amount of
detergent recommended
Take the level of soiling and water
hardness into account.
Too little detergent results in:
–
Laundry not getting properly clean
and with time it may become grey
and hard to the touch.
–
Greasy particles clinging to laundry.
–
Limescale deposits on the heater
elements.
Too much detergent results in:
–
Excessive foam which causes a low
level of agitation and poor wash,
rinse and spin results.
–
High water consumption (an
additional rinse cycle will
automatically switch in).
–
A burden to the environment.
4. Add detergent
36