Operation Manual

Shortening the door panel
The door panel can be shortended to
match the height with the adjacent
cabinetry.
The measure X equals the space from
the bottom of the washer door to the
bottom of the adjacent cabinet.
Cut the bottom of the door panel with a
jigsaw according to X.
Cut the side decor bars with a
hacksaw.
Installation
^
Open the door.
^ To remove the door panel unscrew
the 10 screws (arrows) from the door
sheet panel.
^ Remove the three decor bars from
the door panel by unscrewing the
screws.
^ Cut the bottom of the door panel
and
the two side decor bars
by X.
^
Drill four holes into the door panel to
fix the lower decor bar.
^
Install the decor bars and the door
panel.
To install a decor panel, check if it
need to shortend too.
Installation
46