Operation and Installation Guide
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Help protect our environment
- Guide to the washer
- Before using for the first time
- 1. Prepare the laundry
- 2. Load the laundry
- 3. Select a program
- 4. Selecting program settings
- 5. Add detergent
- 6. Start the program - Program end
- Spin cycle
- Delay Start
- Program guide
- Changing the programme sequence
- Detergent
- Cleaning and care
- Frequently asked questions
- Problem solving guide
- A wash program cannot be started
- The following fault message appears in the display and the program has been canceled
- A message appears in the display at the end of the program
- General problems with the washer
- Poor wash results
- The drum door cannot be opened
- Opening the drum door during a power failure
- After sales service
- MIELE
- Installation
- Setting the language
Before using for the first time
10
The appliance must be correctly
installed and connected before the
first use. Please see the "Installation
instructions."
This washing machine has
undergone thorough testing in the
factory, there may be some residual
water in the drum from this process.
Running a spin cycle before the first use
is, for safety reasons, not possible. To
activate the spin cycle a wash program
must be run without laundry or
detergent.
Turn on the water supply.
Press the I-On / 0-Offbutton. The
washer is turned on.
The Welcome screen shows once the
washer is turned on for the first time.
The Welcome screen will not show after
the washer has run for more than 1
hour.
The display now shows the language
setting.
Setting the display language
The default setting for the display
language is German. The display
language can be adjusted.
Language
OK
deutsch
Select the desired language by
pressing the left menu button
Confirm the setting with the right OK
button.
Shipping strut reminder
The shipping struts must be
removed before the first use to avoid
machine damage.
Confirm that the shipping struts have
been removed by pressing OK.
The washer is now ready for the first
use.
Starting the first wash program
Select program
Press the program button Sanitize.
Press the Start button.
Once the program has finished the first
use is complete. The washer can be
used.