Operation and Installation Guide
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Help protect our environment
- Guide to the washer
- Before using for the first time
- 1. Prepare the laundry
- 2. Load the laundry
- 3. Select a program
- 4. Selecting program settings
- 5. Add detergent
- 6. Start the program - Program end
- Spin cycle
- Delay Start
- Program guide
- Changing the programme sequence
- Detergent
- Cleaning and care
- Frequently asked questions
- Problem solving guide
- A wash program cannot be started
- The following fault message appears in the display and the program has been canceled
- A message appears in the display at the end of the program
- General problems with the washer
- Poor wash results
- The drum door cannot be opened
- Opening the drum door during a power failure
- After sales service
- MIELE
- Installation
- Setting the language
Frequently asked questions
39
The drum door cannot be opened
Problem Possible cause and solution
The drum door cannot
be opened by pressing
the Door button.
The washing machine is not connected to the power
supply and/or is not switched on.
Insert the plug in the socket and switch on and/or
switch the washing machine on with the I-On/0-Off
button.
The child safety lock is activated.
Deactivate the child safety lock as described in the
"Activating the child safety lock" section in,
"Starting the program - Program end."
The door was not correctly engaged.
Press hard against the lock side of the door and
then press the Door button.
Power failure
Open the door as described in the "Opening the
drum door during a power failure" in the
Frequently asked questions section of thie
manual..
There is still water in the drum and the machine is
unable to drain.
Clean the filters and the pumps.
For safety reasons, the door cannot be opened if the
suds temperature is higher than 131°F (55°C).
Allow the program to finish or cancel it and wait
until the temperature in the drum has dropped.