Operation and Installation Guide
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Help protect our environment
- Guide to the washer
- Before using for the first time
- 1. Prepare the laundry
- 2. Load the laundry
- 3. Select a program
- 4. Selecting program settings
- 5. Add detergent
- 6. Start the program - Program end
- Spin cycle
- Delay Start
- Program guide
- Changing the programme sequence
- Detergent
- Cleaning and care
- Frequently asked questions
- Problem solving guide
- A wash program cannot be started
- The following fault message appears in the display and the program has been canceled
- A message appears in the display at the end of the program
- General problems with the washer
- Poor wash results
- The drum door cannot be opened
- Opening the drum door during a power failure
- After sales service
- MIELE
- Installation
- Setting the language
Frequently asked questions
41
Once the flow of water stops:
Remove the drain filter completely.
Clean it thoroughly.
Remove any foreign objects (e.g.
buttons, coins, etc.) and lint from the
filter housing. Turn the impeller by
hand to check that it rotates freely.
Put the drain filter back in place and
secure it.
Make sure the drain filter is
securely tightened. Otherwise there
is a risk of water leakage during use.
To avoid loss of detergent, pour approx.
2 quarts (2 liters) of water into the
detergent dispenser drawer after
cleaning the drain filter. Excess water
will be pumped out automatically before
the next wash program.
Opening the drum door
Make sure the machine is turned
off and the drum has stopped
moving. A moving drum is
dangerous.
To open the door, pull down on the
ring in the upper right corner of the
access area.