User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- TwinDos
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Load the washing machine
- 4. Select programme settings
- 5. Add detergent
- 6. Start the programme - the end of a programme
- Spinning
- Delay start
- Programme chart
- Options
- Garment care label symbols
- Programme sequence
- Changing the programme sequence
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Miele recommended detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Fabric conditioner and liquid starch at the end of the programme
- Cleaning and care
- Problem solving guide
- The programme does not start
- The following fault messages appear in the display and the programme stops
- The following fault messages appear in the display at the end of the programme
- The following fault messages appear in the display at the end of the programme
- Problems with TwinDos
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power failure
- After sales service
- Installation and connection
- Front view
- Rear view
- Installation surface
- Transporting the washing machine to its installation site
- Removing the transit bars
- Re-fitting the transit bars
- Levelling the machine
- The water protection system
- Connection to the water supply
- Connection to the drainage system
- Electrical connection U.K.
- WARNING: THIS APPLIANCE MUST BE EARTHED
- Technical data
- Consumption data
- Settings
- Optional accessories
4. Select programme settings
31
Selecting a spin speed
You can alter the pre-set spin speed
of a wash programme.
Press the Spin speed button.
The following will appear in the display:
Spin speed rpm1600
Set the spin speed you want with the
and sensors and confirm your
selection with the OK sensor.
Select options
Press the button for the option you
want.
The indicator light in the button will
come on.
Not all options are suitable for use
with every programme. You can only
select options which are compatible
with the programme being used.
See "Options".
Switch on delay start (if re‐
quired)
The start of a programme can be de‐
layed from 15 minutes up to 24 hours,
allowing you to make use of night-time
economy electricity rates, for example.
See "Delay start".