User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- TwinDos
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Load the washing machine
- 4. Select programme settings
- 5. Add detergent
- 6. Start the programme - the end of a programme
- Spinning
- Delay start
- Programme chart
- Options
- Garment care label symbols
- Programme sequence
- Changing the programme sequence
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Miele recommended detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Fabric conditioner and liquid starch at the end of the programme
- Cleaning and care
- Problem solving guide
- The programme does not start
- The following fault messages appear in the display and the programme stops
- The following fault messages appear in the display at the end of the programme
- The following fault messages appear in the display at the end of the programme
- Problems with TwinDos
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power failure
- After sales service
- Installation and connection
- Front view
- Rear view
- Installation surface
- Transporting the washing machine to its installation site
- Removing the transit bars
- Re-fitting the transit bars
- Levelling the machine
- The water protection system
- Connection to the water supply
- Connection to the drainage system
- Electrical connection U.K.
- WARNING: THIS APPLIANCE MUST BE EARTHED
- Technical data
- Consumption data
- Settings
- Optional accessories
Delay start
39
With delay start you can choose when
you want the programme to start. You
can delay the start of the programme
from 15 minutes up to a maximum of 24
hours, allowing you to make use of
night-time economy electricity rates, for
example.
To select delay start
Press the Delay start button.
The following will appear in the display:
Start in h00 :00
Use the and sensors to enter
the hour and confirm your entry with
the OK sensor.
The display will change:
Start in h05: 00
Use the and sensors to enter
the minutes and confirm your entry
with the OK sensor.
Tip: The values will count upwards and
downwards automatically if you touch
the or sensor continuously.
To begin delay start
Press the Start/Stop button to begin
delay start and the wash programme.
The following will appear in the display:
Start in h05: 00
When the delay start time has elapsed,
the programme will begin and the dis‐
play will show the programme duration
and the programme sequence.
To change delay start
You can change delay start at any time.
Press the Delay start button.
Change the time
Touch the OK sensor.
Start in h05 :29
Now enter the time you want.
To cancel delay start and begin
the programme straight away
Press the Delay start button.
Change the time
Touch the sensor.
Start immediately
Touch the OK sensor. The wash pro‐
gramme will start immediately.