Technical Information Date: June 7, 2004 To: Technical Service Subject: Washer/Dryer Stand W1113, 1119, 1203, 1213, 1215 T1302, 1303, 1322C, 1323C, 1329C, 1403, 1405
Washer Stand Washer Stand Note: The washer/dryer stand is designed for use with washers and dryers only. Use for any other purpose may result in damage to the machine or personal injury. DO NOT USE OR PLACE A STACKED WASHER AND DRYER ON THIS STAND! Carry out the following steps prior to installing the stands. Drawer Removal Pull the drawer out all the way. Lift upward to release and remove see Fig. 2. Rear Panel Removal Remove the rear panel screws (Torx T20) and remove the rear panel, see Fig.
Washer Stand Installation • Drain the unit, before laying it on its side. • Remove the shipping struts • Lay the washer on its right side. Be sure to lay the unit on a flat, soft underlay (i.e. carpet) • Remove the washers feet • Using the threaded studs and nuts provided (M10), screw 2 nuts midway onto each threaded stud. • Screw the threaded studs (M 10) into the washer and tighten them see Fig. 5. • Install a washer (10.2 x 32 x 2) on each threaded stud. • Fit the stand onto the studs.