User's Manual

Setting the water softener
^
Turn the machine off.
^
Turn the program selector to "Stop"
f.
^
Press and hold the "Display" and
"Start" buttons. At the same time,
turn the machine on with the "On/Off"
button. The display shows the current
program status "P...".
The "Fill/Drain" indicator will
illuminate.
^
Press the "Drying" button once. "E01"
appears in the display.
^ Turn the program selector to the
1-o’clock position.
The display shows "19". (Factory
setting of the water softener in
gr/gal).
^ Press and hold the "Display" button
until the desired setting water
hardness (in gr/gal) shows up in the
display.
The counter starts with "0" after
reaching "60".
^
Press the "Start" button. "SP" appears
in the display.
^
Press the "Start" button again. The
setting will be stored and the display
field clears.
If there is a fault, it will be helpful to
know the water hardness of the local
water supply.
^
Enter the local water hardness level
here:
^
If your water is already soft and you
would like to deactivate the water
softener, set the hardness setting to
"0".
Water softener
14