Operating instructions

With the help of the following notes minor faults in the performance of the appli
-
ance, some of which may result from incorrect operation, can be put right without
contacting the Service Department.
Repair work to electrical machines should only be carried out by a suitably
qualified engineer in accordance with local and national safety regulations. Un
-
authorised repairs could be dangerous.
Fault Possible cause Remedy
The I/h On/Start indi
-
cator light does not
light up. The
programme does not
start.
There is no power
supply to the machine.
Check that
–
the door is properly closed.
–
the plug is correctly in
-
serted in the socket and the
mains electricity supply is
switched on.
– the fuse or circuit breaker
has not tripped.
The p check light
flashes, although the
programme has fin-
ished as usual.
The water inlet is re-
stricted.
– Open the stopcock fully.
– Check the inlet hoses for
kinks.
– The water pressure is too
low
The filters in the inlet
hoses are blocked.
–
Clean the filters (see sec
-
tion "Cleaning the filters in
the water inlet").
The indicator light goes out
when the programme selector
is turned to the r End posi
-
tion.
Problem solving guide
31