User Manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washer-dryer
- Before the first use
- Environmentally friendly washing and drying
- Washing
- Drying
- Washing and Drying
- Rinse out fluff programme
- Changing the programme sequence
- Delay start/SmartStart
- Cleaning and care
- Problem solving guide
- A programme cannot be started
- Programme cancellation and fault indicator light
- Fault indicator light lights up at the end of a programme
- During the programme, a symbol appears in the time display
- General problems with the washer-dryer
- General problems with the washer-dryer
- General problems with the washer-dryer
- An unsatisfactory wash result
- Unsatisfactory drying result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Garment care label symbols
- Installation
- Technical data
- Consumption data
- Programmable functions
- Choosing and selecting programmable functions
- Editing and saving the programmable function
- Exiting the programming level
- PIN code
- switch-off status
- Memory
- Gentle action
- Temperature reduction
- Maximum rinse level
- Suds cooling
- Display brightness
- Cottons drying levels
- Minimum iron drying levels
- Extended cool down
- Compressed laundry protection
- Remote control
- SmartGrid (only functional in selected countries)
- RemoteUpdate
- Switching off Wi-Fi
- Copyright and licences for the communication module
- Detergents and care products
Operating the washer-dryer
17
i
Start/Add laundrysensor
– The programme can be started as
soon as the sensor is flashing on
and off. Touching the Start/Add
laundry sensor starts the selected
programme. The sensor lights up
constantly.
– Once the programme has been
started, the Start/Add laundry
sensor allows you to add laundry.
j
Optical interface
For service technicians.
k
Delay start sensor with arrow
sensors and
With Delay start you can delay the
start of a programme.
Please see “Delay start/SmartStart”
for more information.
l
Programme selector
For selecting programmes and for
switching off the appliance. The
washer-dryer is switched on by
selecting a programme. You can
switch the washer-dryer off by
turning the programme selector to
the position.
How the control panel works
The sensors react to fingertip contact.
Selection is possible as long as the
respective sensor is illuminated.
If a sensor is brightly lit, this means it is
currently selected.
If a sensor is dimly lit, this means it can
be selected.
Applications
You can use this washer-dryer to:
- wash separately
Maximum load (depending on
programme) 8.0kg.
- dry separately
Maximum load (depending on
programme) 4.0kg.
or
- wash and dry in a continuous
sequence
Maximum load (depending on
programme) 4.0kg.