User Manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washer-dryer
- Before the first use
- Environmentally friendly washing and drying
- Washing
- Drying
- Washing and Drying
- Rinse out fluff programme
- Changing the programme sequence
- Delay start/SmartStart
- Cleaning and care
- Problem solving guide
- A programme cannot be started
- Programme cancellation and fault indicator light
- Fault indicator light lights up at the end of a programme
- During the programme, a symbol appears in the time display
- General problems with the washer-dryer
- General problems with the washer-dryer
- General problems with the washer-dryer
- An unsatisfactory wash result
- Unsatisfactory drying result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Garment care label symbols
- Installation
- Technical data
- Consumption data
- Programmable functions
- Choosing and selecting programmable functions
- Editing and saving the programmable function
- Exiting the programming level
- PIN code
- switch-off status
- Memory
- Gentle action
- Temperature reduction
- Maximum rinse level
- Suds cooling
- Display brightness
- Cottons drying levels
- Minimum iron drying levels
- Extended cool down
- Compressed laundry protection
- Remote control
- SmartGrid (only functional in selected countries)
- RemoteUpdate
- Switching off Wi-Fi
- Copyright and licences for the communication module
- Detergents and care products
Drying
43
2. Loading the drum
Opening the door
Reach under the door grip and pull
the door open.
Check the drum for pets or foreign
objects before loading it with
laundry.
Load the laundry loosely in the drum.
Overloading places a strain on the
textiles and affects drying results.
Observe the maximum loads listed in
the Programme chart.
Closing the door
Make sure that no items are caught
between the door and the seal.
Shut the door with a gentle swing.
Detergent dispensing aids, e.g.
plastic dispenser balls, can melt
during the drying programme and
cause damage to the machine and
the laundry.
These dispensing aids must be
removed from the laundry before
drying.
The mains water tap must be kept
open for drying.
3. Selecting a programme
Switching the washer-dryer on
Turn the programme selector to a
programme.
The control panel lights up.
Selecting a programme
Turn the programme selector to the
required programme.
The estimated programme running time
is shown in the time display and the
preset temperature and spin speed light
up in the control panel.
- Using the MobileStart programme
selector position
Turn the programme selector to the
MobileStart position.