User Manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washer-dryer
- Before the first use
- Environmentally friendly washing and drying
- Washing
- Drying
- Washing and Drying
- Rinse out fluff programme
- Changing the programme sequence
- Delay start/SmartStart
- Cleaning and care
- Problem solving guide
- A programme cannot be started
- Programme cancellation and fault indicator light
- Fault indicator light lights up at the end of a programme
- During the programme, a symbol appears in the time display
- General problems with the washer-dryer
- General problems with the washer-dryer
- General problems with the washer-dryer
- An unsatisfactory wash result
- Unsatisfactory drying result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Garment care label symbols
- Installation
- Technical data
- Consumption data
- Programmable functions
- Choosing and selecting programmable functions
- Editing and saving the programmable function
- Exiting the programming level
- PIN code
- switch-off status
- Memory
- Gentle action
- Temperature reduction
- Maximum rinse level
- Suds cooling
- Display brightness
- Cottons drying levels
- Minimum iron drying levels
- Extended cool down
- Compressed laundry protection
- Remote control
- SmartGrid (only functional in selected countries)
- RemoteUpdate
- Switching off Wi-Fi
- Copyright and licences for the communication module
- Detergents and care products
Problem solving guide
59
With the help of the following guide, minor faults in the performance of the
appliance, some of which may result from incorrect operation, can be remedied
without contacting Miele. This will save you time and money because you won't
need a service call.
Please note that a call-out charge will be applied to unnecessary service visits
where the problem could have been rectified as described in these operating
instructions.
A programme cannot be started
Problem Possible cause and remedy
The control panel
remains dark.
There is no power to the machine.
Check whether the mains plug is plugged in and
switched on.
Check whether the circuit breaker has tripped.
The washer-dryer has switched off automatically to
save energy.
Switch the washer-dryer on again by turning the
programme selector.
and alternate in the
time display.
The door is not closed properly. The door lock could
not engage.
Close the door again.
Start the programme again.
If the fault message appears again, contact Miele.