User Manual

Problem solving guide
67
Unsatisfactory drying result
Problem Possible cause and remedy
The laundry is too damp
after a drying cycle.
The load is too small. The electronics could not
assess the residual moisture correctly.
 In the future, use the Warm air programme for
small amounts of laundry.
During the spin cycle, the laundry formed a ring in
the drum because the laundry was distributed
unevenly.
The laundry formed a ring during the thermospin
because it was too damp or because the spin speed
was set too high.
 Open the door and loosen the laundry.
 Start the drying programme again with a lower
spin speed.
The laundry feels damp
after drying.
Warm laundry can feel damp.
 Spread the laundry out to cool it down.
The laundry is too damp
or too dry after a drying
cycle.
The desired residual moisture level is between two
drying levels.
 Change the level of drying as described in
“Settings - Drying levels”.
There is still water in
the drum after drying.
There is a blockage in the water outlet.
 Clean the drain filter and the drain pump as
described in “Opening the door in the event of a
blocked drain outlet and/or power cut” and check
the height of the drainage point.