User Manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washer-dryer
- Before the first use
- Environmentally friendly washing and drying
- Washing
- Drying
- Washing and Drying
- Rinse out fluff programme
- Changing the programme sequence
- Delay start/SmartStart
- Cleaning and care
- Problem solving guide
- A programme cannot be started
- Programme cancellation and fault indicator light
- Fault indicator light lights up at the end of a programme
- During the programme, a symbol appears in the time display
- General problems with the washer-dryer
- General problems with the washer-dryer
- General problems with the washer-dryer
- An unsatisfactory wash result
- Unsatisfactory drying result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Garment care label symbols
- Installation
- Technical data
- Consumption data
- Programmable functions
- Choosing and selecting programmable functions
- Editing and saving the programmable function
- Exiting the programming level
- PIN code
- switch-off status
- Memory
- Gentle action
- Temperature reduction
- Maximum rinse level
- Suds cooling
- Display brightness
- Cottons drying levels
- Minimum iron drying levels
- Extended cool down
- Compressed laundry protection
- Remote control
- SmartGrid (only functional in selected countries)
- RemoteUpdate
- Switching off Wi-Fi
- Copyright and licences for the communication module
- Detergents and care products
Installation
*INSTALLATION*
76
Then pull the transit bar out.
Removing the right transit bar
Push the flap outwards and turn the
transit bar 90° using the enclosed
spanner.
Then pull the transit bar out.
Covering the holes
Risk of injury from sharp edges!
There is a risk of injury from reaching
into holes that are not covered.
The holes for the transit bars must be
covered after the transit bars have
been removed.
Press the flaps firmly shut until they
click into place.