User Manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washer-dryer
- Before the first use
- Environmentally friendly washing and drying
- Washing
- Drying
- Washing and Drying
- Rinse out fluff programme
- Changing the programme sequence
- Delay start/SmartStart
- Cleaning and care
- Problem solving guide
- A programme cannot be started
- Programme cancellation and fault indicator light
- Fault indicator light lights up at the end of a programme
- During the programme, a symbol appears in the time display
- General problems with the washer-dryer
- General problems with the washer-dryer
- General problems with the washer-dryer
- An unsatisfactory wash result
- Unsatisfactory drying result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Garment care label symbols
- Installation
- Technical data
- Consumption data
- Programmable functions
- Choosing and selecting programmable functions
- Editing and saving the programmable function
- Exiting the programming level
- PIN code
- switch-off status
- Memory
- Gentle action
- Temperature reduction
- Maximum rinse level
- Suds cooling
- Display brightness
- Cottons drying levels
- Minimum iron drying levels
- Extended cool down
- Compressed laundry protection
- Remote control
- SmartGrid (only functional in selected countries)
- RemoteUpdate
- Switching off Wi-Fi
- Copyright and licences for the communication module
- Detergents and care products
Installation
*INSTALLATION*
77
Refitting the transit bars
Risk of damage from incorrect
transport.
The washer-dryer may become
damaged if moved without the transit
bars in place.
Keep the transit bars in a safe place.
Fit them again if the washer-dryer is
to be moved (e.g. when moving
house).
Opening the flaps
Push against the catch with a pointed
object, e.g. a narrow screwdriver.
The flap will open.
Fitting the transit bars
Install the transit bars in reverse order
to their removal.
Useful tip: If you lift the drum slightly,
the transit bars can be pushed in more
easily.
Installing under a continuous
worktop
Building under kits* must only be
installed/dismantled by a specialist.
- A special building under kit* is
required. The cover plate included in
the building under kit* replaces the lid
of the washer-dryer. It is necessary to
fit the cover plate for electrical safety
reasons.
- Connections for electricity, water and
drainage should be installed in such a
way that they remain accessible
when the washer-dryer is in its final
position.
The building under kit includes
installation instructions.
* Optional accessories