User Manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washer-dryer
- Before the first use
- Environmentally friendly washing and drying
- Washing
- Drying
- Washing and Drying
- Rinse out fluff programme
- Changing the programme sequence
- Delay start/SmartStart
- Cleaning and care
- Problem solving guide
- A programme cannot be started
- Programme cancellation and fault indicator light
- Fault indicator light lights up at the end of a programme
- During the programme, a symbol appears in the time display
- General problems with the washer-dryer
- General problems with the washer-dryer
- General problems with the washer-dryer
- An unsatisfactory wash result
- Unsatisfactory drying result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Garment care label symbols
- Installation
- Technical data
- Consumption data
- Programmable functions
- Choosing and selecting programmable functions
- Editing and saving the programmable function
- Exiting the programming level
- PIN code
- switch-off status
- Memory
- Gentle action
- Temperature reduction
- Maximum rinse level
- Suds cooling
- Display brightness
- Cottons drying levels
- Minimum iron drying levels
- Extended cool down
- Compressed laundry protection
- Remote control
- SmartGrid (only functional in selected countries)
- RemoteUpdate
- Switching off Wi-Fi
- Copyright and licences for the communication module
- Detergents and care products
Programmable functions
85
The programmable functions are used
to alter the washer-dryer’s electronics
to suit changing requirements.
Programmable functions can be
altered at any time.
Programming is carried out in 9 steps
(, , ...) using the sensors.
Opening the programming level
Before you begin, ensure the following:
- The washer-dryer is switched on and
the programme selector is pointing to
a programme.
- The door of the washer-dryer is open.
Touch the Start/Add laundry sensor
and hold it down whilst carrying out
steps –.
Close the washer-dryer door.
Wait until the Start/Add laundry
sensor lights up constantly...
...and then release the Start/Add
laundry sensor.
After a few seconds, , for example,
will light up in the time display.
Choosing and selecting
programmable functions
The number of the programmable
function will appear in the display as
and a number: e.g. .
Touch the or sensor to scroll to
the next or previous programmable
function:
Programmable functions
Keypad tone
PIN code
Display switch-off status
Memory
8 Gentle action
Temperature reduction
Maximum rinse level
Suds cooling
Low water pressure
Display brightness
Cottons drying level
Minimum iron drying level
Extended cool down
Laundry ring prevention
Remote control
SmartGrid
RemoteUpdate
Confirm the selected programmable
function by touching the Start/Add
laundry sensor.