User Manual

Programmable functions
92
The message  will appear in the time
display if an update is available.
You can install the update immediately
or postpone this until later. When the
washer-dryer is switched on again, you
will be reminded about the update.
The update may take several minutes.
Please note the following about the
RemoteUpdate function:
- You will only receive a message when
an update is available.
- Once an update has been installed, it
cannot be undone.
- Do not switch off the washer-dryer
during an update. Otherwise, the
update will be aborted and will not be
installed.
- Some updates can only be carried
out by a Miele service technician.
Activating/Deactivating
The RemoteUpdate function is
activated as standard. A new update
will be downloaded automatically but
will only be installed if you initiate
installation manually. Deactivate the
RemoteUpdate function if you do not
want any updates to be downloaded
automatically.
Options
 = Off
 = On (factory default)
Starting the update
After the washer-dryer is switched on,
appears in the time display.
 Touch the Start/Add laundry sensor.
will flash in the time display. The
update starts.
Bars in the time display show the
progress of the update:
 = 0%
 = 100%
Postponing the update
After the washer-dryer is switched on,
appears in the time display.
 Touch the  sensor.
The running time of the selected
programme appears in the time display.
The next time you switch on the
appliance, you will be prompted to start
the update again.