User's Manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Load the washing machine
- 4. Select programme settings
- 5. Add detergent
- 6. Starting the programme
- 7. End of programme
- Spinning
- Programme chart
- Garment care label symbols
- Extra options
- Programme sequence
- Changing the programme sequence
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Using fabric conditioner or starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Cleaning and care
- Problem solving guide
- The programme does not start
- Fault message after a programme has been interrupted.
- Fault message at the end of a programme
- Fault message at the end of a programme
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Technical data
- Consumption data
- Settings
- Accessing the Settings menu
- Selecting settings
- Changing a setting
- Closing the settings menu
- _
- Buzzer volume
- Keypad tone
- Welcome tone
- Code
- Units
- Brightness
- Disp. switch-off stat.
- Programme info
- Memory
- Long p-wash Cotton
- Soak duration
- Gentle action
- Temp. reduction
- Water plus
- Water plus level
- Maximum rinse level
- Suds cooling
- Low water pressure
- Anti-crease
- Miele@home
- _
- SmartGrid
- RemoteUpdate
- Detergents and care products
4. Select programme settings
28
Delay start/SmartStart
Delay start
With the delay start function, you can
delay the start of the programme.
This function is active when the set-
ting SmartGrid is switched off.
The hours can be set from 00 to 24.
The minutes can be set in 15minute in-
crements from 00 to 45.
Setting the delay start time
Touch the sensor control.
The following will appear in the display:
Start in
OK
h:0000
Set the hours with thesensor
controls. Confirm with the OKsensor
control.
The display will change:
Start in
OK
h0006:
Set the minutes with thesensor
controls. Confirm with the OKsensor
control.
Tip: The values will count upwards and
downwards automatically if you keep
your finger on thesensor control.
Cancelling delay start
The selected delay start period can be
cancelled before the programme starts.
Touch the sensor control.
The selected delay start period will ap-
pear in the display.
Set a time value of 00:00 h with
the sensor controls. Confirm
with the OKsensor control.
The selected delay start time has been
cancelled.
After the programme has started, the
selected delay start period can only be
changed or cancelled by interrupting
the programme.
Altering delay start
The selected delay start time period can
be changed before the programme
start.
Touch the sensor control.
Change the specified time and con-
firm with the OK sensor control.