User's Manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Load the washing machine
- 4. Select programme settings
- 5. Add detergent
- 6. Starting the programme
- 7. End of programme
- Spinning
- Programme chart
- Garment care label symbols
- Extra options
- Programme sequence
- Changing the programme sequence
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Using fabric conditioner or starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Cleaning and care
- Problem solving guide
- The programme does not start
- Fault message after a programme has been interrupted.
- Fault message at the end of a programme
- Fault message at the end of a programme
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Technical data
- Consumption data
- Settings
- Accessing the Settings menu
- Selecting settings
- Changing a setting
- Closing the settings menu
- _
- Buzzer volume
- Keypad tone
- Welcome tone
- Code
- Units
- Brightness
- Disp. switch-off stat.
- Programme info
- Memory
- Long p-wash Cotton
- Soak duration
- Gentle action
- Temp. reduction
- Water plus
- Water plus level
- Maximum rinse level
- Suds cooling
- Low water pressure
- Anti-crease
- Miele@home
- _
- SmartGrid
- RemoteUpdate
- Detergents and care products
4. Select programme settings
29
SmartStart
The SmartStart function lets you
define a period of time during which
your washing machine will start auto-
matically. The appliance will start on
receipt of a signal, e.g. from your en-
ergy supplier, that indicates that the
electricity tariff is particularly econom-
ical.
This function is active when the
SmartGrid setting is switched on.
The time period can be defined
between 15minutes and 24hours. Dur-
ing this period, the washing machine
waits for the signal from the energy
supplier. If no signal is sent during the
defined period, the washing machine
starts the wash programme.
Setting the time period
If you have activated the SmartGrid
function in Settings, SmartStart in in-
stead of Start in will appear in the dis-
play when you touch the sensor
control (see “Settings – SmartGrid”).
The procedure for setting this is the
same as for setting the time for delay
start.
Use thesensor controls to enter
the hour and confirm your entry with
the OK sensor control.
The hour will be saved and the minute
number block will be highlighted.
Use thesensor controls to enter
the minutes and confirm your entry
with the OK sensor control.
Press the Start/Add laundrysensor
control to start the wash programme
with SmartStart.
The following will appear in the display:
SmartStart
OK