User's Manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Load the washing machine
- 4. Select programme settings
- 5. Add detergent
- 6. Starting the programme
- 7. End of programme
- Spinning
- Programme chart
- Garment care label symbols
- Extra options
- Programme sequence
- Changing the programme sequence
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Using fabric conditioner or starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Cleaning and care
- Problem solving guide
- The programme does not start
- Fault message after a programme has been interrupted.
- Fault message at the end of a programme
- Fault message at the end of a programme
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Technical data
- Consumption data
- Settings
- Accessing the Settings menu
- Selecting settings
- Changing a setting
- Closing the settings menu
- _
- Buzzer volume
- Keypad tone
- Welcome tone
- Code
- Units
- Brightness
- Disp. switch-off stat.
- Programme info
- Memory
- Long p-wash Cotton
- Soak duration
- Gentle action
- Temp. reduction
- Water plus
- Water plus level
- Maximum rinse level
- Suds cooling
- Low water pressure
- Anti-crease
- Miele@home
- _
- SmartGrid
- RemoteUpdate
- Detergents and care products
Spinning
37
Omitting the final spin (Rinse
hold)
Set the spin speed to (Rinse
hold).
The laundry is not spun after the final
rinse and remains in the rinse water.
This helps to prevent creasing if the
laundry is not going to be removed from
the drum immediately after the end of
the programme.
Ending a programme with a spin
cycle
The display showsRinse hold altern-
ately with the ideal spin speed.
Touch the Start/Add laundrysensor
control to start the final spin.
Ending a programme without a spin
cycle
Reduce the spin speed to 0.
Touch the flashingStart/Add laundry
sensor control.
Interim spin
There is a spin cycle after the main
wash and between the rinses. A reduc-
tion in the final spin speed will also re-
duce the interim spin speed as appro-
priate.
Omitting the interim-spin and
the final spin
Before the start of the wash pro-
gramme, reduce the spin speed to 0.
After the last rinse, the water will be
pumped away and the anti-crease
phase will switch on.
In some programmes an additional rinse
is introduced with this setting.